[PATCH RESEND 0/6 v10] gpio: Add block GPIO

[Wolfgang Grandegger]

On 12/17/2012 02:51 PM, Roland Stigge wrote:
> Hi Wolfgang,
> 
> On 12/17/2012 02:32 PM, Roland Stigge wrote:
>> And I guess Russell is right: If possible, we should write outputs
>> simultaneously via ODSR (plus OWER/OWDR/OWSR) instead of separate set/clear.
>>
>> I wonder if we need to save/restore the state of OWSR at every write
>> operation or if we need/can cache it. Assuming that block GPIO are the
>> only code in the kernel that manipulates ODSR.
> 
> Can you please test the following:
> 
> +static void at91_gpiolib_set_block(struct gpio_chip *chip, unsigned long mask, unsigned long val)
> +{
> +       struct at91_gpio_chip *at91_gpio = to_at91_gpio_chip(chip);
> +       void __iomem *pio = at91_gpio->regbase;
> +
> +       __raw_writel(~mask, pio + PIO_OWDR);

This would also disable normal GPIOs configured for output! From the
manual I understand that if the pin is configured for output, we could
either use PIO_SODR/PIO_CODR to set/clear the bits individually or
PIO_ODSR for synchronous data output. But than we need to care about the
non-block GPIO outputs as well... requiring a read-modify-write cycle :(.

Wolfgang.