[PATCH 3/8] ARM: ux500: Specify the ux5x0 MMCI regulator's on/off GPIO as high-enable

[Lee Jones]

If not specified, the GPIO control bit is inverted by default i.e.
low-enable and high-disable. This is not the case with the MMCI
regulator, hence it will turn on during a disable and off when
regulator_enable() is invoked.

Acked-by: Linus Walleij <linus.walleij at linaro.org>
Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 arch/arm/boot/dts/dbx5x0.dtsi |    2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm/boot/dts/dbx5x0.dtsi b/arch/arm/boot/dts/dbx5x0.dtsi
index 6b1aa6d..88f90217 100644
--- a/arch/arm/boot/dts/dbx5x0.dtsi
+++ b/arch/arm/boot/dts/dbx5x0.dtsi
@@ -638,6 +638,8 @@
 			regulator-name = "mmci-reg";
 			regulator-type = "voltage";
 
+			enable-active-high;
+
 			states = <1800000 0x1
 				  2900000 0x0>;
 
-- 
1.7.9.5