[PATCH 1/6] ARM: clocksource: Initialise early

Simon Horman horms at verge.net.au
Wed Dec 12 19:41:44 EST 2012


On Tue, Dec 11, 2012 at 01:51:27PM +0100, Laurent Pinchart wrote:
> Hi Simon,
> 
> Thanks for the patch.
> 
> Could you please CC LKML on this one ? It targets a wider audience than the 
> SH-specific patches.

Sure, good thinking.

> 
> On Tuesday 11 December 2012 12:07:29 Simon Horman wrote:
> > Initialise clock sources early, since some subsystems rely on them to
> > initialize
> > 
> > Signed-off-by: Simon Horman <horms+renesas at verge.net.au>
> > 
> > ---
> > 
> > v3
> > * Initial post
> > ---
> >  drivers/Makefile |    8 +++++---
> >  1 file changed, 5 insertions(+), 3 deletions(-)
> > 
> > diff --git a/drivers/Makefile b/drivers/Makefile
> > index a16a8d0..eba9b58 100644
> > --- a/drivers/Makefile
> > +++ b/drivers/Makefile
> > @@ -37,6 +37,11 @@ obj-$(CONFIG_XEN)		+= xen/
> >  # regulators early, since some subsystems rely on them to initialize
> >  obj-$(CONFIG_REGULATOR)		+= regulator/
> > 
> > +# clocksource early, since some subsystems rely on them to initialize
> > +ifndef CONFIG_ARCH_USES_GETTIMEOFFSET
> > +obj-y				+= clocksource/
> > +endif
> > +
> >  # tty/ comes before char/ so that the VT console is the boot-time
> >  # default.
> >  obj-y				+= tty/
> > @@ -114,9 +119,6 @@ obj-y				+= firmware/
> >  obj-$(CONFIG_CRYPTO)		+= crypto/
> >  obj-$(CONFIG_SUPERH)		+= sh/
> >  obj-$(CONFIG_ARCH_SHMOBILE)	+= sh/
> > -ifndef CONFIG_ARCH_USES_GETTIMEOFFSET
> > -obj-y				+= clocksource/
> > -endif
> >  obj-$(CONFIG_DCA)		+= dca/
> >  obj-$(CONFIG_HID)		+= hid/
> >  obj-$(CONFIG_PPC_PS3)		+= ps3/
> -- 
> Regards,
> 
> Laurent Pinchart
> 



More information about the linux-arm-kernel mailing list