[PATCH 3/7] dmaengine: ste_dma40: set dma max seg size

[Fabio Baltieri]

From: Per Forlin <per.forlin at stericsson.com>

Maximum DMA seg size is (0xffff x data_width).  If max seg
size is not set it deafults to 64k.  This results in failure
if transferring 64k in byte mode.
Large seg sizes may be supported by splitting large transfer.

Signed-off-by: Per Forlin <per.forlin at stericsson.com>
Acked-by: Linus Walleij <linus.walleij at linaro.org>
Signed-off-by: Fabio Baltieri <fabio.baltieri at linaro.org>
---
 drivers/dma/ste_dma40.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/dma/ste_dma40.c b/drivers/dma/ste_dma40.c
index ae55091..16c96f5 100644
--- a/drivers/dma/ste_dma40.c
+++ b/drivers/dma/ste_dma40.c
@@ -345,6 +345,7 @@ struct d40_base {
 	int				  irq;
 	int				  num_phy_chans;
 	int				  num_log_chans;
+	struct device_dma_parameters	  dma_parms;
 	struct dma_device		  dma_both;
 	struct dma_device		  dma_slave;
 	struct dma_device		  dma_memcpy;
@@ -3363,6 +3364,13 @@ static int __init d40_probe(struct platform_device *pdev)
 	if (err)
 		goto failure;
 
+	base->dev->dma_parms = &base->dma_parms;
+	err = dma_set_max_seg_size(base->dev, STEDMA40_MAX_SEG_SIZE);
+	if (err) {
+		d40_err(&pdev->dev, "Failed to set dma max seg size\n");
+		goto failure;
+	}
+
 	d40_hw_init(base);
 
 	dev_info(base->dev, "initialized\n");
-- 
1.7.12.1