[PATCH V7 2/7] ARM: dt: change .dtb build rules to build in dts directory

[Stephen Warren]

On 12/03/2012 09:15 AM, Rob Herring wrote:
> On 11/27/2012 05:29 PM, Stephen Warren wrote:
>> From: Grant Likely <grant.likely at secretlab.ca>
>>
>> The current rules have the .dtb files build in a different directory
>> from the .dts files. The only reason for this is that it was what
>> PowerPC has done historically. This patch changes ARM to use the generic
>> dtb rule which builds .dtb files in the same directory as the source .dts.
> 
> [snip]
> 
>> diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile
>> index a17d5ab..cb217f8 100644
>> --- a/arch/arm/boot/dts/Makefile
>> +++ b/arch/arm/boot/dts/Makefile
>> @@ -136,4 +136,12 @@ dtb-$(CONFIG_ARCH_VT8500) += vt8500-bv07.dtb \
>>  	wm8650-mid.dtb
>>  dtb-$(CONFIG_ARCH_ZYNQ) += zynq-zc702.dtb
>>  
>> +targets += dtbs
>>  endif
>> +
>> +dtbs: $(addprefix $(obj)/, $(dtb-y))
>> +	# *.dtb used to be generated in the directory above. Clean out the
>> +	# old build results so people don't accidentally use them.
>> +	rm -f $(obj)/../*.dtb
> 
> Do you intend for this to print out? Seems a little noisy to me for a
> one-time problem. Are you trying to tell users the dtb files moved or
> just prevent them from using the old ones? Quietly removing them would
> still accomplish the latter.

Oh, I just wasn't thinking; I guess this should be @rm or similar. Will
you fix this up locally since you've applied the patches?