[PATCH V3 07/12] ata/sata_mv: Remove conditional compilation of clk code

[Lothar Waßmann]

Hi,

Andrew Lunn writes:
> > This is what i was thinking too and thats why floated this version of patch.
> > But as Andrew said, clk API support is enabled for them, but still they
> > don't have a clk for sata. To get this working, there are two solutions:
> > - Create dummy clk for sata for that platform, so clk_get doesn't fail.
> > - Check for error before every call to clk APIs after clk_get().
> > 
> > Andrew favored the second one. Which means, even on platforms
> > with clk API defined and clk enable required, if there are some issues
> > with lookup table, and clk_get() fails, system may hang when registers
> > are accessed. For this i favored first one.
> 
> I'm not too sure how you are going to achieve 1)
> 
> config SATA_MV
>         tristate "Marvell SATA support"
>         help
>           This option enables support for the Marvell Serial ATA family.
>           Currently supports 88SX[56]0[48][01] PCI(-X) chips,
>           as well as the newer [67]042 PCI-X/PCIe and SOC devices.
> 
> So this driver can be used with anything which has a PCI(-X) or PCIe
> bus, or Orion SoC and a few PowerPC SoCs.
> 
> The SoCs are not too bad, we know which ones they are and we can add
> dummy entries to their device tree. However, how do you want to handle
> the PCI devices? Create the dummy entry somewhere in the middle of the
> PCI core?
> 
> Thought not.
> 
AFAICT the PCI archs do not have HAVE_CLK enabled. Thus they will have
a dummy clk API in place that provides the driver with a non-error
clk_get() return value.


Lothar Waßmann
-- 
___________________________________________________________

Ka-Ro electronics GmbH | Pascalstraße 22 | D - 52076 Aachen
Phone: +49 2408 1402-0 | Fax: +49 2408 1402-10
Geschäftsführer: Matthias Kaussen
Handelsregistereintrag: Amtsgericht Aachen, HRB 4996

www.karo-electronics.de | info at karo-electronics.de
___________________________________________________________