[PATCH 8/8] ARM: omap_hsmmc: remove platform data dma_mask and initialization

[Tony Lindgren]

* Russell King - ARM Linux <linux at arm.linux.org.uk> [120420 08:15]:
> On Thu, Apr 19, 2012 at 11:07:42AM -0700, Tony Lindgren wrote:
> > * Russell King - ARM Linux <linux at arm.linux.org.uk> [120419 10:46]:
> > > On Wed, Apr 18, 2012 at 06:39:14PM -0700, Tony Lindgren wrote:
> > > > Cool, you almost got it. Got it working for n800 and 770 with the following
> > > > patch. Only extremely light testing done now so careful with this patch too..
> > > > 
> > > > Had to hack in support for the src_port and dst_port that's needed for
> > > > omap_set_dma_src/dest_params on omap1.
> > > 
> > > What's the relationship between these ports and the DMA request signal?
> > > Is there a document which describes this?
> > 
> > It's the source and destination addresses bus port, so it's more related
> > to the addresses than request signal. I guess routing of the DMA request
> > signal is what it really does.
> > 
> > I'm now wondering if it might be possible to set it automatically based on
> > source and destination address.

There's probably some latency involved that requires setting the src
and dst port earlier, so I doubt that setting it automatically based on
the src and dst address would work correctly.

> > There's some information in the omap5912 trm on pages 717 and 718:
> > 
> > http://www.ti.com/litv/pdf/spru742
> > 
> > It says for CSDP source port "This field identifies the port originator of
> > the transfer."
> 
> Is there a reason not to use EMIFF as for the memory port for any DMA
> activity between a peripheral and system (kernel) memory?

I don't think we have any device to device cases, and it's unlikely that
we'll get them either.
 
> It looks to me like TIPB is the right port to use for anything except
> camera and LCD?
>
> If that's true, we can solve the memory side of the problem very easily -
> we know that prep_slave_sg() will always souce from system memory, so
> the port for that will be known.

OK
 
> For the peripheral side of the transfer, I think we should case this on
> the request signal as the combinations seem to be very limited - and it
> looks like this knowledge is specific to the DMA controller rather than
> the peripheral.

OK sounds good to me.

Regards,

Tony