[PATCH v4] i2c: Add device tree support to i2c-pnx.c

[Roland Stigge]

Hi,

On 04/19/2012 06:07 PM, Wolfram Sang wrote:
>> + - clock-frequency: desired I2C bus clock frequency in Hz,
>> Default: 100000 Hz + - pnx,timeout: I2C bus timeout in
>> milliseconds, Default: 10 ms
> 
> I'd like to repeat my question to the devicetree folks here: Can we
> have timeout generic? It doesn't make sense to me to have that per
> vendor again and again.

Sounds completely reasonable.

To help make the devicetree conversion into 3.5, I would prefer to
integrate the "vendor,timeout" as-is if a longish standardization
process would block this, considering that we luckily only have 2-3 of
such timeout definitions currently.

I'd volunteer to clean up later by preparing a patch when there is a
standard timeout defined.

If we have a solution soon, I will prepare a new version of the patch,
of course, in the next days.

>> +	i2c2: i2c at 400a8000 { +		compatible = "nxp,pnx-i2c"; +		reg =
>> <0x400a8000 0x100>; +		interrupt-parent = <&mic>; +		interrupts =
>> <50 0>; +		#address-cells = <1>; +		#size-cells = <0>; +
>> clock-frequency = <0x186a0>; +		pnx,timeout = <0x64>;
> 
> Did you change this, too? Timeouts are better readable in dec :)

Right. But even when removing the "0x" in the timeout line above, it's
still hex, see Documentation/devicetree/booting-without-of.txt

Or did I get sth. wrong?

Thanks,

Roland