[PATCH 10/16 v2] drivers/gpio: represent gpio-nomadik as an IRQ controller in DT documentation

[Lee Jones]

From: Lee Jones <lee.jones at linaro.org>
Date: Fri, 13 Apr 2012 16:05:26 +0100
Subject: [PATCH 10/16] drivers/gpio: represent gpio-nomadik as an IRQ
 controller in DT documentation

Now gpio-nomadik has proper bindings devices initialised by Device Tree
entries are able to use the chained GPIO IRQ lines it provides. This
patch aims to reflect that in the gpio-nmk documentation.

Signed-off-by: Lee Jones <lee.jones at linaro.org>
---
 .../devicetree/bindings/gpio/gpio-nmk.txt          |    2 ++
 1 files changed, 2 insertions(+), 0 deletions(-)

diff --git a/Documentation/devicetree/bindings/gpio/gpio-nmk.txt b/Documentation/devicetree/bindings/gpio/gpio-nmk.txt
index 3856789..ee87467 100644
--- a/Documentation/devicetree/bindings/gpio/gpio-nmk.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio-nmk.txt
@@ -13,6 +13,7 @@ Required properties:
                                   4 = active high level-sensitive.
                                   8 = active low level-sensitive.
 - gpio-controller       : Marks the device node as a GPIO controller.
+- interrupt-controller  : Marks the device node as an interrupt controller.
 - gpio-bank             : Specifies which bank a controller owns.
 - st,supports-sleepmode : Specifies whether controller can sleep or not
 
@@ -24,6 +25,7 @@ Example:
                         interrupts = <0 120 0x4>;
                         #gpio-cells = <2>;
                         gpio-controller;
+                        interrupt-controller;
                         supports-sleepmode;
                         gpio-bank = <1>;
                 };
-- 
1.7.9.1