[PATCH 3/9] ARM: at91: add at91sam9g20ek boards dt support

[Mohammed, Afzal]

+ omap ml

Hi Jean, Andrew, Nicolas,

On Wed, Apr 11, 2012 at 21:31:13, Jean-Christophe PLAGNIOL-VILLARD wrote:
> +	ahb {
> +		apb {
> +			dbgu: serial at fffff200 {
> +				status = "okay";
> +			};
> +
> +			usart0: serial at fffb0000 {
> +				status = "okay";
> +			};
> +
> +			usart1: serial at fffb4000 {
> +				status = "okay";
> +			};
> +
> +			macb0: ethernet at fffc4000 {
> +				phy-mode = "rmii";
> +				status = "okay";
> +			};
> +
> +			usb1: gadget at fffa4000 {
> +				atmel,vbus-gpio = <&pioC 5 0>;
> +				status = "okay";
> +			};
> +		};
> +
> +		nand0: nand at 40000000 {
> +			nand-bus-width = <8>;
> +			nand-ecc-mode = "soft";
> +			nand-on-flash-bbt;
> +			status = "okay";

I have a few queries about handling static memory controller (SMC) of ATMEL

1. How is SMC configured when DT is used ?
2. With "d6a0166 atmel/nand: add DT support", ek_add_device_nand() is no more
present (which was earlier configuring SMC), so is SMC configuration handled
by Kernel on DT boot or is it done by bootloader when DT ?
3. How ek_add_device_dm9000() is going to be achieved with DT ?
4. Is there any plan to create a driver out of SMC code & use DT with it ?

Reason for bringing these queries is that TI OMAP chips have GPMC [1], SMC in ATMEL
seems somewhat similar and currently GPMC is configured in platform code, &
we are creating a driver out of that code [2]. There are different views on where
GPMC driver should go, mfd, misc folders etc, but could not yet get concrete
suggestions even with a loud cry.

If ATMEL is also going driver way, then probably our voice together may be
heard and hopefully it will expedite the matter.

Regards
Afzal

[1]
GPMC (General Purpose Memory Controller) in brief:
GPMC is an unified memory controller dedicated to interfacing external
memory devices like
 Asynchronous SRAM like memories and application specific integrated circuit devices.
 Asynchronous, synchronous, and page mode burst NOR flash devices NAND flash
 Pseudo-SRAM devices

GPMC has to be configured as required by timings of the connected
peripheral. It needs to be configured only initially. Once it is
configured it can be used to handle different protocols like NAND,
NOR. Various kinds of devices like ethernet, uart, usb, fpga etc
can work using GPMC interface. GPMC has a seperate additional
functionality of NAND handling

[2] https://lkml.org/lkml/2012/4/5/210