[PATCHv6 05/19] I2C: OMAP: Fix the interrupt clearing in OMAP4

[Shubhrajyoti D]

On OMAP4 we were writing 1 to IRQENABLE_CLR which cleared only
the arbitration lost interrupt. The patch intends to fix the same by writing 0
to the IE register clearing all interrupts.

This is based on the work done by Vikram Pandita <vikram.pandita at ti.com>.

The  changes from the original patch ...
-  Does not use the IRQENABLE_CLR register to clear as it is not mentioned
  to be legacy register IRQENABLE_CLR helps in  atomically
  setting/clearing specific interrupts, instead use the OMAP_I2C_IE_REG as we are
  clearing all interrupts.

Cc: Vikram Pandita <vikram.pandita at ti.com>
Signed-off-by: Shubhrajyoti D <shubhrajyoti at ti.com>
---
 drivers/i2c/busses/i2c-omap.c |    6 ++----
 1 files changed, 2 insertions(+), 4 deletions(-)

diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
index 45389db..2769f67 100644
--- a/drivers/i2c/busses/i2c-omap.c
+++ b/drivers/i2c/busses/i2c-omap.c
@@ -1179,10 +1179,8 @@ static int omap_i2c_runtime_suspend(struct device *dev)
 		_dev->dev_lost_count = _dev->get_context_loss_count(dev);
 
 	_dev->iestate = omap_i2c_read_reg(_dev, OMAP_I2C_IE_REG);
-	if (_dev->dtrev == OMAP_I2C_IP_VERSION_2)
-		omap_i2c_write_reg(_dev, OMAP_I2C_IP_V2_IRQENABLE_CLR, 1);
-	else
-		omap_i2c_write_reg(_dev, OMAP_I2C_IE_REG, 0);
+
+	omap_i2c_write_reg(_dev, OMAP_I2C_IE_REG, 0);
 
 	if (_dev->rev < OMAP_I2C_OMAP1_REV_2) {
 		iv = omap_i2c_read_reg(_dev, OMAP_I2C_IV_REG); /* Read clears */
-- 
1.7.4.1