[PATCH 1/3] ARM: S5PV210: Enable I2C0 bus on GONI board

[Kukjin Kim]

Sylwester Nawrocki wrote:
> 
> Add I2C0 bus platform device for camera sensors.
> 
> Signed-off-by: Sylwester Nawrocki <s.nawrocki at samsung.com>
> Signed-off-by: Kyungmin Park <kyungmin.park at samsung.com>
> ---
>  arch/arm/mach-s5pv210/Kconfig     |    1 +
>  arch/arm/mach-s5pv210/mach-goni.c |    4 ++++
>  2 files changed, 5 insertions(+), 0 deletions(-)
> 
> diff --git a/arch/arm/mach-s5pv210/Kconfig b/arch/arm/mach-s5pv210/Kconfig
> index 53aabef..b0aa462 100644
> --- a/arch/arm/mach-s5pv210/Kconfig
> +++ b/arch/arm/mach-s5pv210/Kconfig
> @@ -75,6 +75,7 @@ config MACH_GONI
>  	bool "GONI"
>  	select CPU_S5PV210
>  	select S5P_GPIO_INT
> +	select S3C_DEV_I2C0

NO...Where is S3C_DEV_I2C0?
Basically, platform device of i2c0 which is in
arch/arm/plat-samsung/dev-i2c0.c is always selected.

>  	select S3C_DEV_FB
>  	select S5P_DEV_FIMC0
>  	select S5P_DEV_FIMC1
> diff --git a/arch/arm/mach-s5pv210/mach-goni.c
b/arch/arm/mach-s5pv210/mach-
> goni.c
> index e22d511..fc34575 100644
> --- a/arch/arm/mach-s5pv210/mach-goni.c
> +++ b/arch/arm/mach-s5pv210/mach-goni.c
> @@ -800,6 +800,7 @@ static struct platform_device *goni_devices[]
__initdata
> = {
>  	&s5pv210_device_iis0,
>  	&s3c_device_usb_hsotg,
>  	&samsung_device_keypad,
> +	&s3c_device_i2c0,
>  	&s3c_device_i2c1,
>  	&s3c_device_i2c2,
>  	&wm8994_fixed_voltage0,
> @@ -827,6 +828,9 @@ static void __init goni_machine_init(void)
>  	/* Radio: call before I2C 1 registeration */
>  	goni_radio_init();
> 
> +	/* I2C0 */
> +	s3c_i2c0_set_platdata(NULL);
> +
>  	/* I2C1 */
>  	s3c_i2c1_set_platdata(NULL);
>  	i2c_register_board_info(1, i2c1_devs, ARRAY_SIZE(i2c1_devs));
> --
> 1.7.3.5

Others, ok...please re-work this against on latest my for-next.

Thanks.

Best regards,
Kgene.
--
Kukjin Kim <kgene.kim at samsung.com>, Senior Engineer,
SW Solution Development Team, Samsung Electronics Co., Ltd.