[PATCH] omap4: Fix ULPI PHY init for ES1.0 SDP (Re: 4430SDP boot failure)

[Russell King - ARM Linux]

On Thu, Jan 13, 2011 at 02:22:06PM +0530, Anand Gadiyar wrote:
> Tony Lindgren wrote:
> >  	/* Power on the ULPI PHY */
> > -	if (gpio_is_valid(OMAP4SDP_MDM_PWR_EN_GPIO)) {
> > -		/* FIXME: Assumes pad is already muxed for GPIO mode */
> > -		gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY
> VMDM_3V3");
> > +	status = gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY
> VMDM_3V3");
> > +	if (status)
> > +		pr_err("%s: Could not get USBB1 PHY GPIO\n");
> 
> Tony,
> 
> This throws up a build warning as there's no parameter corresponding to
> the %s. Showed up in linux-next as of today.

It's pretty obvious that the above is wrong, and the compiler would
have caught it with a warning when building it.  Was the above patch
not build-tested before it was committed?

Given the very sorry state of OMAP in mainline at present, I'm surprised
that this kind of stuff is still going on...