[PATCH/RFC 1/3] ARM: S5P: Add a platform callback for MIPI CSIS PHY control

[Sylwester Nawrocki]

Hi Kukjin,

thank you for the update.

On 01/13/2011 10:29 AM, Kukjin Kim wrote:
> Sylwester Nawrocki wrote:
>>
>> The phy_enable callback in struct s5p_platform_mipi_csis is added
>> to allow the CSIS driver to control its PHY enable and reset signals.
>> This allows to use same MIPI CSIS driver across various SoCs.
>>
>> Signed-off-by: Sylwester Nawrocki <s.nawrocki at samsung.com>
>> Signed-off-by: Kyungmin Park <kyungmin.park at samsung.com>
>> ---
>>  arch/arm/plat-s5p/dev-csis0.c              |    2 +-
>>  arch/arm/plat-s5p/dev-csis1.c              |    2 +-
>>  arch/arm/plat-s5p/include/plat/csis.h      |   28 --------------------
>>  arch/arm/plat-s5p/include/plat/mipi_csis.h |   39
>> ++++++++++++++++++++++++++++
>>  4 files changed, 41 insertions(+), 30 deletions(-)
>>  delete mode 100644 arch/arm/plat-s5p/include/plat/csis.h
>>  create mode 100644 arch/arm/plat-s5p/include/plat/mipi_csis.h
>>
...
> 
> I think should be separated like following.
> 
> If required, ...
> 
> 1. change copyright
> 2. rename csis.h to mipi_csis.h

I don't want to bother with a separate patches for that, just prefer
to drop the above changes.

> 3. add phy enable feature

OK, I would reduce the patch to that change only.

Regards,
-- 
Sylwester Nawrocki
Samsung Poland R&D Center