[PATCH v5 3/3] omap3: beaglexm: fix power on of DVI

[Nishanth Menon]

Tony Lindgren had written, on 01/11/2011 06:15 PM, the following:
> * Nishanth Menon <nm at ti.com> [110111 15:54]:
>> Tony Lindgren had written, on 01/11/2011 05:23 PM, the following:
>> [..]
>>>> -
>>>> -	gpio_request(gpio + 1, "EHCI_nOC");
>>>> -	gpio_direction_input(gpio + 1);
>>>> +	if (omap3_beagle_get_rev() != OMAP3BEAGLE_BOARD_XM) {
>>>> +		gpio_request(gpio + 1, "EHCI_nOC");
>>>> +		gpio_direction_input(gpio + 1);
>>>> +	}
>>> The return value for gpio_request must be checked.
>> Ack.
>> we can go down two paths:
>> a) I can redo this patch as in v6.patch (attached)
> 
> Yes let's do that, one comment below though..
> 
>> OR
>> b) we take this patch and do another one cleaning the function up -
>> gpio-check.patch
> 
> That can be done later.
ok

>  
>> +	if (omap3_beagle_get_rev() == OMAP3BEAGLE_BOARD_XM) {
>> +		r = gpio_request(gpio + 1, "nDVI_PWR_EN");
>> +		if (!r) {
>> +			r = gpio_direction_output(gpio + 1, 0);
>> +			if (r)
>> +				gpio_free(gpio + 1);
>> +		}
>> +		if (r)
>> +			pr_err("%s: unable to configure nDVI_PWR_EN\n",
>> +				__func__);
>> +		r = gpio_request(gpio + 2, "DVI_LDO_EN");
>> +		if (!r) {
>> +			r = gpio_direction_output(gpio + 2, 1);
>> +			if (r)
>> +				gpio_free(gpio + 1);
>> +		}
>> +		if (r)
>> +			pr_err("%s: unable to configure DVI_LDO_EN\n",
>> +				__func__);
>> +	}
>> +
> 
> Should the second gpio_free be gpio + 2 instead of gpio + 1?
oops.. yep. will fix and send out a v6 for this alone. thanks for the check.

-- 
Regards,
Nishanth Menon