[PATCH v5 03/22] gpio/omap: make gpio_context part of gpio_bank structure

[Kevin Hilman]

Santosh <santosh.shilimkar at ti.com> writes:

> On Thursday 04 August 2011 04:34 PM, Tarun Kanti DebBarma wrote:
>> From: Charulatha V<charu at ti.com>
>>
>> Currently gpio_context array used to save gpio bank's context, is used only for
>> OMAP3 architecture. Move gpio_context as part of gpio_bank structure so that it
>> can be specific to each gpio bank and can be used for any OMAP architecture
>>
>> Signed-off-by: Charulatha V<charu at ti.com>
>> ---
> Few comments.
>

[...]

>> @@ -1494,33 +1490,31 @@ void omap2_gpio_resume_after_idle(void)
>>   void omap_gpio_save_context(void)
>>   {
>>   	struct gpio_bank *bank;
>> -	int i = 0;
>>
>>   	list_for_each_entry(bank,&omap_gpio_list, node) {
>> -		i++;
>>
>>   		if (!bank->loses_context)
>>   			continue;
>>
>> -		gpio_context[i].irqenable1 =
>> +		bank->context.irqenable1 =
>>   			__raw_readl(bank->base + OMAP24XX_GPIO_IRQENABLE1);
>> -		gpio_context[i].irqenable2 =
>> +		bank->context.irqenable2 =
>>   			__raw_readl(bank->base + OMAP24XX_GPIO_IRQENABLE2);
>
> The context restore procedure should be done carefully. For instance
> IRQ enabled register should be restored last to avoid any spurious
> interrupts.

For the sake of clean, easy-to-review patches, this kind of functional
change should be a separate patch.

The goal of $SUBJECT patch is simply to move the context struct into the
bank struct, not change the order of the save restore.

Any changing of the order of save/restore should be in a dedicated patch
with a descriptive changelog since that is changing behavior of the code.

Kevin