[RFC PATCH 6/6] hwmon: OMAP4: On die temperature sensor driver

[Kevin Hilman]

Rajendra Nayak <rnayak at ti.com> writes:

> On 8/23/2011 5:28 AM, Kevin Hilman wrote:
>> Rajendra Nayak<rnayak at ti.com>  writes:
>>
>> [...]
>>
>>> FWIK, its a one time requirement to set the clock rate to the
>>> right rate the device can operate in based on what a platform
>>> supports.
>>
>> Except $SUBJECT patch hard-codes the clock rate for all platforms in the
>> driver.
>
> The device has a requirement to operate in a 1Mhz to 2Mhz range. 

You mean the device on OMAP4 has this requirement.   

Will this requirement exist on every platform that uses any version of
this IP (or future similar IPs)?  I suspect not.

> So the driver is using a clk_round_rate() to get the closest rate
> supported and sets it using a clk_set_rate().
>
>>
>> If the clock rate is to be platform-specific, it should be done in
>> platform-specific code.
>
> I am fine if this needs to be moved to platform-specific code, but I
> wasn't quite sure this needs to be done in clock framework as was
> suggested.

No, it should't be in clock framework.  But since the frequency range is
platform-specific, it should be initialized in platform-specific code.
Having min/max parameters passed by platform data as suggested by
J. Keerthy is fine.

Probably even better is to have the driver have a default min/max rang
which can be overridden by platform_data only if needed.

Kevin