[RFC PATCH 6/6] hwmon: OMAP4: On die temperature sensor driver

[Rajendra Nayak]

On 8/23/2011 5:28 AM, Kevin Hilman wrote:
> Rajendra Nayak<rnayak at ti.com>  writes:
>
> [...]
>
>> FWIK, its a one time requirement to set the clock rate to the
>> right rate the device can operate in based on what a platform
>> supports.
>
> Except $SUBJECT patch hard-codes the clock rate for all platforms in the
> driver.

The device has a requirement to operate in a 1Mhz to 2Mhz range. So the
driver is using a clk_round_rate() to get the closest rate supported and
sets it using a clk_set_rate().

>
> If the clock rate is to be platform-specific, it should be done in
> platform-specific code.

I am fine if this needs to be moved to platform-specific code, but I
wasn't quite sure this needs to be done in clock framework as was
suggested.

>
> Kevin