[PATCH V2 5/6] spi/spi-pl022: Call pl022_dma_remove(pl022) only if enable_dma is true

[Viresh Kumar]

pl022_dma_remove() should be called only if enable_dma is true. There is no
point calling it when pl022_dma_probe() is not called, which again depends on
enable_dma.

Signed-off-by: Viresh Kumar <viresh.kumar at st.com>
Tested-by: Linus Walleij <linus.walleij at linaro.org>
---
 drivers/spi/spi-pl022.c |    8 ++++++--
 1 files changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-pl022.c b/drivers/spi/spi-pl022.c
index d1bcc79..01e84e3 100644
--- a/drivers/spi/spi-pl022.c
+++ b/drivers/spi/spi-pl022.c
@@ -2238,7 +2238,9 @@ err_spi_register:
 err_start_queue:
 err_init_queue:
 	destroy_queue(pl022);
-	pl022_dma_remove(pl022);
+	if (platform_info->enable_dma)
+		pl022_dma_remove(pl022);
+
 	free_irq(adev->irq[0], pl022);
 	pm_runtime_disable(&adev->dev);
 err_no_irq:
@@ -2266,7 +2268,9 @@ pl022_remove(struct amba_device *adev)
 	if (destroy_queue(pl022) != 0)
 		dev_err(&adev->dev, "queue remove failed\n");
 	load_ssp_default_config(pl022);
-	pl022_dma_remove(pl022);
+	if (pl022->master_info->enable_dma)
+		pl022_dma_remove(pl022);
+
 	free_irq(adev->irq[0], pl022);
 	clk_disable(pl022->clk);
 	clk_put(pl022->clk);
-- 
1.7.2.2