[PATCH 01/20] mtd: pxa3xx_nand: refuse the flash definition get from platform

[Mike Rapoport]

Lei Wen wrote:
> On Mon, May 24, 2010 at 9:21 PM, Mike Rapoport <mike at compulab.co.il> wrote:
>> Lei Wen wrote:
>>> Hi Mike,
>>>
>>> On Mon, May 24, 2010 at 7:00 PM, Mike Rapoport <mike at compulab.co.il>
>>> wrote:
>>>> Hi Lei,
>>>>
>>>> Lei Wen wrote:
>>>>> Hi Mike,
>>>>>
>>>> 2) I don't like hadrcoding of NAND parameters into the driver. You remove
>>>> *deprecetad* CONFIG_MTD_NAND_PXA3xx_BUILTIN configuration option and
>>>> instead
>>>> you enforce use of built-in definitions. The driver in its current state
>>>> is
>>>> robust enough to allow platforms to define optimized NAND timings either
>>>> in
>>>> the bootloader or in the kernel. If you don't like that multiple
>>>> platforms
>>>> define the same flash chip create an enumeration of built-in types and
>>>> let
>>>> platforms to use this enumeration to select the NAND chip. But, anyway,
>>>> there should be a fallback mode that will support NAND chips that are not
>>>> defined in the driver, probably with suboptimal timings.
>>> Original driver also use hardcoding. And in bootloader, this timing
>>> parameter is also hard coding.
>>> We cannot deduce a parameter set only from the nand id, that is why we
>>> need a table to preset it.
>>> If one nand chip is not listed in that table, the chip id would still
>>> be printed out, so that we can do something for that.
>>> If we encourage people to continue on this, we would not able to
>>> really "driver" that nand.
>> Currently pxa3xx-nand has three operational modes:
>> - use NAND parameters supplied by the platform
>> - use presets configured by the bootloader chain
>> - use built-in NAND parameters, marked as deprecated in favor of the first
>> two
>> You remove the first two modes completely and require that each and every
>> NAND chip used on pxa3xx based platform will be added to the driver. This
>> way you make the driver less robust and harder to use for platform
>> developers, not mentioning you're breaking the existing platforms.
>> In my opinion, the driver *may* support built-in definitions for certain
>> NAND flashes and *must* support configuration of the NAND parameters by the
>> platform code and bootloader.
>>
> 
> Hi Mike,
> 
> Well... I would submit another patch set which would reserve a way
> that platform could pass its parameter setting.
> Like specify the certain type of nand chip parameter for each chip
> select. Is that ok for you?
> 
> For bootloader pass parameter method, I think this way should be
> dropped... For there is attributed which we could not tell from
> registers...
> What do you think of this?

Can you please elaborate what are the attributes that cannot be detected?

> Thanks,
> Lei


-- 
Sincerely yours,
Mike.