[PATCH] ARM: Samsung: Add platform support code for OneNAND controller

[Marek Szyprowski]

Hello,

On Thursday, May 20, 2010 10:49 AM Ben Dooks wrote:

> On Thu, May 20, 2010 at 08:59:05AM +0200, Marek Szyprowski wrote:
> > This patch adds setup code for Samsung OneNAND controller driver. The
> > driver needs to be aware on which SoC it is running, so the actual
> > device id is being changed in cpu init code. S3C64xx SoCs have 2 OneNAND
> > controllers while S5PC100 and S5PC110 has only one.
> >
> > Signed-off-by: Marek Szyprowski <m.szyprowski at samsung.com>
> > Signed-off-by: Kyungmin Park <kyungmin.park at samsung.com>
> 
> Ok, in future please try and keep a core and then have the architecture
> additions seperate, it makes it very difficult to deal with any problems
> whilst merging and means there is a higher possibility of a problem during
> this.

Ok, but I'm still not 100% sure how should I handle case like this properly.
I thought that separating platform files from the driver itself would help
merging it, because each part (the driver and platform setup code/register
definitions) can be merged separately by the respective maintainers. Was it
wrong that the platform patch was prepared for the tree after plat-s5pc1xx
moves? 

Best regards
-- 
Marek Szyprowski
Samsung Poland R&D Center