[PATCH 2/3] ARM: MXC: mxcmmc: Teach the driver SDIO operations
Daniel Mack
daniel at caiaq.de
Tue Mar 30 14:32:00 EDT 2010
Successfully tested on MX31 hardware using libertas SDIO peripherals.
Signed-off-by: Daniel Mack <daniel at caiaq.de>
Cc: Sascha Hauer <s.hauer at pengutronix.de>
Cc: Dan Williams <dan.j.williams at intel.com>
Cc: Volker Ernst <volker.ernst at txtr.com>
Cc: Jiri Kosina <jkosina at suse.cz>
---
drivers/mmc/host/mxcmmc.c | 55 ++++++++++++++++++++++++++++++++++++--------
1 files changed, 45 insertions(+), 10 deletions(-)
diff --git a/drivers/mmc/host/mxcmmc.c b/drivers/mmc/host/mxcmmc.c
index 21037ff..83a4545 100644
--- a/drivers/mmc/host/mxcmmc.c
+++ b/drivers/mmc/host/mxcmmc.c
@@ -119,6 +119,7 @@ struct mxcmci_host {
int detect_irq;
int dma;
int do_dma;
+ int use_sdio;
unsigned int power_mode;
struct imxmmc_platform_data *pdata;
@@ -138,6 +139,7 @@ struct mxcmci_host {
int clock;
struct work_struct datawork;
+ spinlock_t lock;
};
static void mxcmci_set_clk_rate(struct mxcmci_host *host, unsigned int clk_ios);
@@ -226,6 +228,8 @@ static int mxcmci_setup_data(struct mxcmci_host *host, struct mmc_data *data)
static int mxcmci_start_cmd(struct mxcmci_host *host, struct mmc_command *cmd,
unsigned int cmdat)
{
+ u32 int_cntr;
+
WARN_ON(host->cmd != NULL);
host->cmd = cmd;
@@ -249,13 +253,15 @@ static int mxcmci_start_cmd(struct mxcmci_host *host, struct mmc_command *cmd,
return -EINVAL;
}
+ int_cntr = INT_END_CMD_RES_EN;
+
if (mxcmci_use_dma(host))
- writel(INT_READ_OP_EN | INT_WRITE_OP_DONE_EN |
- INT_END_CMD_RES_EN,
- host->base + MMC_REG_INT_CNTR);
- else
- writel(INT_END_CMD_RES_EN, host->base + MMC_REG_INT_CNTR);
+ int_cntr |= INT_READ_OP_EN | INT_WRITE_OP_DONE_EN;
+
+ if (host->use_sdio)
+ int_cntr |= INT_SDIO_IRQ_EN;
+ writel(int_cntr, host->base + MMC_REG_INT_CNTR);
writew(cmd->opcode, host->base + MMC_REG_CMD);
writel(cmd->arg, host->base + MMC_REG_ARG);
writew(cmdat, host->base + MMC_REG_CMD_DAT_CONT);
@@ -266,7 +272,12 @@ static int mxcmci_start_cmd(struct mxcmci_host *host, struct mmc_command *cmd,
static void mxcmci_finish_request(struct mxcmci_host *host,
struct mmc_request *req)
{
- writel(0, host->base + MMC_REG_INT_CNTR);
+ u32 int_cntr = 0;
+
+ if (host->use_sdio)
+ int_cntr |= INT_SDIO_IRQ_EN;
+
+ writel(int_cntr, host->base + MMC_REG_INT_CNTR);
host->req = NULL;
host->cmd = NULL;
@@ -536,8 +547,12 @@ static irqreturn_t mxcmci_irq(int irq, void *devid)
dev_dbg(mmc_dev(host->mmc), "%s: 0x%08x\n", __func__, stat);
+ if ((stat & STATUS_SDIO_INT_ACTIVE) && host->use_sdio)
+ mmc_signal_sdio_irq(host->mmc);
+
if (stat & STATUS_END_CMD_RESP)
mxcmci_cmd_done(host, stat);
+
#ifdef HAS_DMA
if (mxcmci_use_dma(host) &&
(stat & (STATUS_DATA_TRANS_DONE | STATUS_WRITE_OP_DONE)))
@@ -674,11 +689,30 @@ static int mxcmci_get_ro(struct mmc_host *mmc)
return -ENOSYS;
}
+static void mxcmci_enable_sdio_irq(struct mmc_host *mmc, int enable)
+{
+ struct mxcmci_host *host = mmc_priv(mmc);
+ unsigned long flags;
+ u32 int_cntr;
+
+ spin_lock_irqsave(&host->lock, flags);
+ host->use_sdio = enable;
+ int_cntr = readl(host->base + MMC_REG_INT_CNTR);
+
+ if (enable)
+ int_cntr |= INT_SDIO_IRQ_EN;
+ else
+ int_cntr &= ~INT_SDIO_IRQ_EN;
+
+ writel(int_cntr, host->base + MMC_REG_INT_CNTR);
+ spin_unlock_irqrestore(&host->lock, flags);
+}
static const struct mmc_host_ops mxcmci_ops = {
- .request = mxcmci_request,
- .set_ios = mxcmci_set_ios,
- .get_ro = mxcmci_get_ro,
+ .request = mxcmci_request,
+ .set_ios = mxcmci_set_ios,
+ .get_ro = mxcmci_get_ro,
+ .enable_sdio_irq = mxcmci_enable_sdio_irq,
};
static int mxcmci_probe(struct platform_device *pdev)
@@ -706,7 +740,7 @@ static int mxcmci_probe(struct platform_device *pdev)
}
mmc->ops = &mxcmci_ops;
- mmc->caps = MMC_CAP_4_BIT_DATA;
+ mmc->caps = MMC_CAP_4_BIT_DATA | MMC_CAP_SDIO_IRQ;
/* MMC core transfer sizes tunable parameters */
mmc->max_hw_segs = 64;
@@ -725,6 +759,7 @@ static int mxcmci_probe(struct platform_device *pdev)
host->mmc = mmc;
host->pdata = pdev->dev.platform_data;
+ spin_lock_init(&host->lock);
if (host->pdata && host->pdata->ocr_avail)
mmc->ocr_avail = host->pdata->ocr_avail;
--
1.7.0
More information about the linux-arm-kernel
mailing list