[PATCH 3/3] ep93xx: SPI driver platform support code

[Mika Westerberg]

This patch adds platform side support code for EP93xx SPI driver. This includes
clock, resources and muxing. There is a new function: ep93xx_register_spi() that
can be used by board support code to register new SPI devices for the board.

Patch depends on the previous patch which adds function ep93xx_chip_revision().

Signed-off-by: Mika Westerberg <mika.westerberg at iki.fi>
---
 arch/arm/mach-ep93xx/clock.c                    |   21 +++++++++++
 arch/arm/mach-ep93xx/core.c                     |   42 +++++++++++++++++++++++
 arch/arm/mach-ep93xx/include/mach/ep93xx-regs.h |    1 +
 arch/arm/mach-ep93xx/include/mach/platform.h    |    2 +
 4 files changed, 66 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-ep93xx/clock.c b/arch/arm/mach-ep93xx/clock.c
index 5f80092..1dc22cc 100644
--- a/arch/arm/mach-ep93xx/clock.c
+++ b/arch/arm/mach-ep93xx/clock.c
@@ -100,6 +100,10 @@ static struct clk clk_pwm = {
 	.parent		= &clk_xtali,
 	.rate		= EP93XX_EXT_CLK_RATE,
 };
+static struct clk clk_spi = {
+	.parent		= &clk_xtali,
+	.rate		= EP93XX_EXT_CLK_RATE / 2,
+};
 
 static struct clk clk_video = {
 	.sw_locked	= 1,
@@ -187,6 +191,7 @@ static struct clk_lookup clocks[] = {
 	INIT_CK("ep93xx-keypad",	NULL,		&clk_keypad),
 	INIT_CK("ep93xx-fb",		NULL,		&clk_video),
 	INIT_CK(NULL,			"pwm_clk",	&clk_pwm),
+	INIT_CK(NULL,			"spi_clk",	&clk_spi),
 	INIT_CK(NULL,			"m2p0",		&clk_m2p0),
 	INIT_CK(NULL,			"m2p1",		&clk_m2p1),
 	INIT_CK(NULL,			"m2p2",		&clk_m2p2),
@@ -480,6 +485,22 @@ static int __init ep93xx_clock_init(void)
 		clk_p.rate / 1000000);
 
 	clkdev_add_table(clocks, ARRAY_SIZE(clocks));
+
+	/*
+	 * EP93xx SSP clock rate was doubled in version E2 and forwards. For
+	 * more information see:
+	 *     http://www.cirrus.com/en/pubs/appNote/AN273REV4.pdf
+	 */
+	if (ep93xx_chip_revision() >= EP93XX_CHIP_REV_E2) {
+		struct clk *clk;
+
+		clk = clk_get(NULL, "spi_clk");
+		if (!IS_ERR(clk)) {
+			clk->rate *= 2;
+			clk_put(clk);
+		}
+	}
+
 	return 0;
 }
 arch_initcall(ep93xx_clock_init);
diff --git a/arch/arm/mach-ep93xx/core.c b/arch/arm/mach-ep93xx/core.c
index 2e496c9..36a7833 100644
--- a/arch/arm/mach-ep93xx/core.c
+++ b/arch/arm/mach-ep93xx/core.c
@@ -31,6 +31,7 @@
 #include <linux/amba/serial.h>
 #include <linux/i2c.h>
 #include <linux/i2c-gpio.h>
+#include <linux/clk.h>
 
 #include <mach/hardware.h>
 #include <mach/fb.h>
@@ -389,6 +390,47 @@ void __init ep93xx_register_eth(struct ep93xx_eth_data *data, int copy_addr)
 	platform_device_register(&ep93xx_eth_device);
 }
 
+static struct resource ep93xx_spi_resources[] = {
+	{
+		.start	= EP93XX_SPI_PHYS_BASE,
+		.end	= EP93XX_SPI_PHYS_BASE + SZ_4K - 1,
+		.flags	= IORESOURCE_MEM,
+	},
+	{
+		.start	= IRQ_EP93XX_SSP,
+		.flags	= IORESOURCE_IRQ,
+	},
+};
+
+static struct platform_device ep93xx_spi_device = {
+	.name		= "ep93xx-spi",
+	.id		= -1,
+	.num_resources	= ARRAY_SIZE(ep93xx_spi_resources),
+	.resource	= ep93xx_spi_resources,
+};
+
+/**
+ * ep93xx_register_spi() - registers spi platform device
+ * @info: ep93xx board specific spi info
+ *
+ * This function registers platform device for the EP93xx SPI controller and
+ * also makes sure that SPI pins are muxed so that I2S is not using those
+ * pins. Caller should allocate necessary GPIO lines and register any SPI
+ * devices before calling this (see also spi_register_board_info()).
+ *
+ * Returns %0 in success and negative value in case of failure.
+ */
+int __init ep93xx_register_spi(struct ep93xx_spi_info *info)
+{
+	/*
+	 * When SPI is used, we need to make sure that I2S is muxed off from
+	 * SPI pins.
+	 */
+	ep93xx_devcfg_clear_bits(EP93XX_SYSCON_DEVCFG_I2SONSSP);
+
+	ep93xx_spi_device.dev.platform_data = info;
+	return platform_device_register(&ep93xx_spi_device);
+}
 
 /*************************************************************************
  * EP93xx i2c peripheral handling
diff --git a/arch/arm/mach-ep93xx/include/mach/ep93xx-regs.h b/arch/arm/mach-ep93xx/include/mach/ep93xx-regs.h
index 93e2ecc..b1e096f 100644
--- a/arch/arm/mach-ep93xx/include/mach/ep93xx-regs.h
+++ b/arch/arm/mach-ep93xx/include/mach/ep93xx-regs.h
@@ -106,6 +106,7 @@
 
 #define EP93XX_AAC_BASE			EP93XX_APB_IOMEM(0x00080000)
 
+#define EP93XX_SPI_PHYS_BASE		EP93XX_APB_PHYS(0x000a0000)
 #define EP93XX_SPI_BASE			EP93XX_APB_IOMEM(0x000a0000)
 
 #define EP93XX_IRDA_BASE		EP93XX_APB_IOMEM(0x000b0000)
diff --git a/arch/arm/mach-ep93xx/include/mach/platform.h b/arch/arm/mach-ep93xx/include/mach/platform.h
index 8603837..1f02147 100644
--- a/arch/arm/mach-ep93xx/include/mach/platform.h
+++ b/arch/arm/mach-ep93xx/include/mach/platform.h
@@ -9,6 +9,7 @@ struct i2c_board_info;
 struct platform_device;
 struct ep93xxfb_mach_info;
 struct ep93xx_keypad_platform_data;
+struct ep93xx_spi_info;
 
 struct ep93xx_eth_data
 {
@@ -49,6 +50,7 @@ void ep93xx_register_i2c(struct i2c_gpio_platform_data *data,
 			 struct i2c_board_info *devices, int num);
 void ep93xx_register_fb(struct ep93xxfb_mach_info *data);
 void ep93xx_register_pwm(int pwm0, int pwm1);
+int ep93xx_register_spi(struct ep93xx_spi_info *info);
 int ep93xx_pwm_acquire_gpio(struct platform_device *pdev);
 void ep93xx_pwm_release_gpio(struct platform_device *pdev);
 void ep93xx_register_keypad(struct ep93xx_keypad_platform_data *data);
-- 
1.5.6.5