bit errors on spitz

[Andy Green]

On 03/12/10 09:07, Somebody in the thread at some point said:

>> Unless there's more to it in the way the zaurus using it that regulator
>> isn't programmable digitally.
>
> OOPS, I made a mistake and linked ISL6721 instead of ISL6271 there.
> Now it is fixed:
> http://www.penguin.cz/~utx/zaurus/datasheets/power/XScale/ISL6271A.pdf
>
> This one has I2C. It is connected to GPIO 3 (PWR_SCL) and GPIO 4
> (PWR_SDA).

Thanks... that defaults to 1.3V on Vcore if you don't touch it.  I guess 
confirm on the CPU datasheet that it's OK for your selected CPU clock speed.

> I guess that Zaurus has a good power design and that voltage should be
> constant enough. CF has a dedicated step down (plus 2.8V power detector

In that case is the PXA CF driver PIO?  Then it can be the same load on 
Vcore issue in disguise.

-Andy