[PATCH 05/29] pxa3xx_nand: set oob length in the runtime

Lei Wen leiwen at marvell.com
Tue Jun 22 09:01:04 EDT 2010


For different command need different oob requirement, set the proper
oob length by different cmd.

Signed-off-by: Lei Wen <leiwen at marvell.com>
---
 drivers/mtd/nand/pxa3xx_nand.c |   25 ++++++++++++++++++-------
 1 files changed, 18 insertions(+), 7 deletions(-)

diff --git a/drivers/mtd/nand/pxa3xx_nand.c b/drivers/mtd/nand/pxa3xx_nand.c
index 50e08db..26c0286 100644
--- a/drivers/mtd/nand/pxa3xx_nand.c
+++ b/drivers/mtd/nand/pxa3xx_nand.c
@@ -274,13 +274,20 @@ static int wait_for_event(struct
pxa3xx_nand_info *info, uint32_t event)

 static void pxa3xx_set_datasize(struct pxa3xx_nand_info *info)
 {
-	/* calculate data size */
+	int oob_enable = info->reg_ndcr & NDCR_SPARE_EN;
+
+	info->data_size = info->page_size;
+	if (!oob_enable) {
+		info->oob_size = 0;
+		return;
+	}
+
 	switch (info->page_size) {
 	case 2048:
-		info->data_size = (info->use_ecc) ? 2088 : 2112;
+		info->oob_size = (info->use_ecc) ? 40 : 64;
 		break;
 	case 512:
-		info->data_size = (info->use_ecc) ? 520 : 528;
+		info->oob_size = (info->use_ecc) ? 8 : 16;
 		break;
 	}
 }
@@ -334,6 +341,7 @@ static int prepare_other_cmd(struct
pxa3xx_nand_info *info, uint16_t cmd)
 	info->ndcb1 = 0;
 	info->ndcb2 = 0;

+	info->oob_size = 0;
 	if (cmd == cmdset->read_id) {
 		info->ndcb0 |= NDCB0_CMD_TYPE(3);
 		info->data_size = 8;
@@ -402,6 +410,9 @@ static int handle_data_pio(struct pxa3xx_nand_info *info)
 	case STATE_PIO_WRITING:
 		__raw_writesl(info->mmio_base + NDDB, info->data_buff,
 				DIV_ROUND_UP(info->data_size, 4));
+		if (info->oob_size > 0)
+			__raw_writesl(info->mmio_base + NDDB, info->oob_buff,
+					DIV_ROUND_UP(info->oob_size, 4));

 		enable_int(info, NDSR_CS0_BBD | NDSR_CS0_CMDD);

@@ -414,6 +425,9 @@ static int handle_data_pio(struct pxa3xx_nand_info *info)
 	case STATE_PIO_READING:
 		__raw_readsl(info->mmio_base + NDDB, info->data_buff,
 				DIV_ROUND_UP(info->data_size, 4));
+		if (info->oob_size > 0)
+			__raw_readsl(info->mmio_base + NDDB, info->oob_buff,
+					DIV_ROUND_UP(info->oob_size, 4));

 		break;
 	default:
@@ -429,7 +443,7 @@ static int handle_data_pio(struct pxa3xx_nand_info *info)
 static void start_data_dma(struct pxa3xx_nand_info *info, int dir_out)
 {
 	struct pxa_dma_desc *desc = info->data_desc;
-	int dma_len = ALIGN(info->data_size, 32);
+	int dma_len = ALIGN(info->data_size + info->oob_size, 32);

 	desc->ddadr = DDADR_STOP;
 	desc->dcmd = DCMD_ENDIRQEN | DCMD_WIDTH4 | DCMD_BURST32 | dma_len;
@@ -835,7 +849,6 @@ static int pxa3xx_nand_config_flash(struct
pxa3xx_nand_info *info,
 	info->cmdset = f->cmdset;
 	info->page_size = f->page_size;
 	info->oob_buff = info->data_buff + f->page_size;
-	info->oob_size = (f->page_size == 2048) ? 64 : 16;
 	info->read_id_bytes = (f->page_size == 2048) ? 4 : 2;

 	/* calculate addressing information */
@@ -894,8 +907,6 @@ static int pxa3xx_nand_detect_config(struct
pxa3xx_nand_info *info)
 	i = __ffs(page_per_block * info->page_size);
 	num_blocks = type->chipsize << (20 - i);

-	info->oob_size = (info->page_size == 2048) ? 64 : 16;
-
 	/* calculate addressing information */
 	info->col_addr_cycles = (info->page_size == 2048) ? 2 : 1;

-- 
1.7.0.4



More information about the linux-arm-kernel mailing list