[PATCH] spi/omap2_mcspi: disable and enable chan between each SPI transfer

[jason]

Grant Likely wrote:
> On Thu, Jun 24, 2010 at 6:12 AM, Jason Wang <jason77.wang at gmail.com> wrote:
>   
>> In current design, the SPI channel is always enable during the period
>> of handling a SPI message, it is risky when more than one SPI transfer
>> are included in a message. Current working route like that:
>> [
>>  SPI channel enable
>>  configure channel
>>  handle transfer #1
>>  configure channel
>>  handle transfer #2
>>  ...
>>  SPI channel disable
>> ]
>> If we can disable channel before configure it and reenable
>> channel after it is configured, it will be more safe.
>>
>> The commit a330ce2 "omap2_mcspi: Flush posted writes" make this risk
>> to a real problem for ads7846 driver on omap3530evm. The
>> ads7846 driver will send a SPI messge which includes,
>> [
>>  TX_ONLY transfer (1 byte)
>>  RX_ONLY transfer (2 bytes)
>>  TX_ONLY transfer (1 byte)
>>  RX_ONLY transfer (2 bytes)
>> ]
>> If we don't add disable/reenable channel between TX and RX transfers,
>> the RX transfer will get wrong datas sent from slave.
>>     
>
> I don't understand the problem description.  Are you talking about
> manipulation of the SS line, or a problem with the internal state on
> the mcspi controller device?  What is the cause of the wrong data (ie.
> is there a protocol error on the wire, or is the SPI controller not
> performing the read correctly?)
>
> Thanks,
> g.
>
>   
Sorry for unclear description.  The problem is like that, when a TX_ONLY 
transfer is
followed by a RX_ONLY transfer, the first data received in RX_ONLY 
transfer will be
the last data(random data) which is received in TX_ONLY transfer instead 
of a meaningful data.

Thing like following logic,
In TX_ONLY transfer:
write data1(trigger transmit), (will receive a data simultaneously, and 
keep it in RX register)
...
write dataN(last data), (will receive the last random data and keep it 
in RX register)
in the following RX_ONLY transfer:
change SPI controller to RX_ONLY mode,
the RXS bit will be set to status register immediately,
write a dummy data to TX register to trigger this session(in fact this  
trigger  doesn't take  effect),
check the RXS bit and read the first data(the first data is the last 
random data received in TX_ONLY transfer).


But if we disable this channel after the TX_ONLY  transfer and reenable 
it  before  the RX_ONLY  transfer,
the trigger action will take effect and a meaningful data  will be  
transfered to RX register.

Thanks,
Jason.

>> Signed-off-by: Jason Wang <jason77.wang at gmail.com>
>> ---
>>  drivers/spi/omap2_mcspi.c |   16 ++++++----------
>>  1 files changed, 6 insertions(+), 10 deletions(-)
>>
>> diff --git a/drivers/spi/omap2_mcspi.c b/drivers/spi/omap2_mcspi.c
>>     
[snip]