pxa300 - DDRAM base value

[Marek Vasut]

Dne Ne 6. června 2010 10:17:00 Eric Miao napsal(a):
> On Sun, Jun 6, 2010 at 1:19 AM, Marek Vasut <marek.vasut at gmail.com> wrote:
> > Dne Út 1. června 2010 07:44:18 balakrishnan napsal(a):
> >> I am working on pxa300 based development board and using Linux 2.6.34.
> >> This Linux kernel already has support for following boards
> >> 1. zylonite_pxa300
> >> 2. cm-x300
> >> 3. colibri-pxa300
> >> 4. littleton
> >> 
> >> My doubt is that pxa300 based boards are using "0xa0000000"  as DDRAM
> >> base and PHYS_OFFSET is also defined in
> >> "arch/arm/mach-pxa/include/mach/memory.h" as 0xa0000000.
> >> But in our board  DDR is mapped in 0x80000000. Does it make any
> >> problem?. Because after mmu is turned ON, my board is hanging.
> >> 
> >> "zreladdr-y   := 0x80008000" is defined in
> >> "arch/arm/mach-pxa/Makefile.boot" file .
> >> my machine_desc is as follows
> >> .phys_io        = 0x40000000,
> >> .io_pg_offst    = (io_p2v(0x40000000) >> 18) & 0xfffc,
> >> .boot_params    = 0x80000100,
> > 
> > Try editing both arch/arm/mach-pxa/Makefile.boot and
> > arch/arm/mach/pxa/include/mach/memory.h
> > 
> >> With Thanks
> >> J.Balakrishnan
> > 
> > The 0x80000000 should be aliased to 0xa0000000, but looking into the PXA
> > docs, it is only on pxa320. Eric, any ideas on this ?
> 
> Should be working on pxa300/310 as well. If it doesn't, check you
> bootloader to make sure the mapping is OK, and memory doesn't exceed
> (0xa000_0000 - 0x8000_0000).

It worked last time I used the pxa310 littleton board, but I can't check on the 
pxa300 zylonite board just yet.

Could you give us your bootloader details ?