[PATCH 05/13] omap: rx51: Set regulator V28 always on

[Tony Lindgren]

From: Jarkko Nikula <jhnikula at gmail.com>

It seems that the battery cover sensor in Nokia N900 is powered from the
V28 domain. Now if this regulator is disabled it causes that the gpio 160
reads only zero which effectively causes uSD removal detection.

Currently the bootloader enabled V28 is kept on but this may change in the
future according to comment in
drivers/regulator/core.c: regulator_has_full_constraints.

Also if there are any consumers on the V28 domain doing regulator_enable
regulator_disable cycle the V28 will be disabled after that.

Prepare for these by defining the V28 as always_on regulator.

Signed-off-by: Jarkko Nikula <jhnikula at gmail.com>
Cc: Adrian Hunter <adrian.hunter at nokia.com>
Signed-off-by: Tony Lindgren <tony at atomide.com>
---
 arch/arm/mach-omap2/board-rx51-peripherals.c |    1 +
 1 files changed, 1 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-omap2/board-rx51-peripherals.c b/arch/arm/mach-omap2/board-rx51-peripherals.c
index 5ddf156..3d95534 100644
--- a/arch/arm/mach-omap2/board-rx51-peripherals.c
+++ b/arch/arm/mach-omap2/board-rx51-peripherals.c
@@ -361,6 +361,7 @@ static struct regulator_init_data rx51_vaux1 = {
 		.name			= "V28",
 		.min_uV			= 2800000,
 		.max_uV			= 2800000,
+		.always_on		= true, /* due battery cover sensor */
 		.valid_modes_mask	= REGULATOR_MODE_NORMAL
 					| REGULATOR_MODE_STANDBY,
 		.valid_ops_mask		= REGULATOR_CHANGE_MODE