[PATCH 02/13] omap: zoom3: wlan board muxing

[Tony Lindgren]

From: Ohad Ben-Cohen <ohadb at ti.com>

Add board muxing to support the wlan wl1271 chip that is
hardwired to mmc2 (third mmc controller) on the ZOOM3.

Signed-off-by: Ohad Ben-Cohen <ohadb at ti.com>
Signed-off-by: Tony Lindgren <tony at atomide.com>
---
 arch/arm/mach-omap2/board-zoom3.c |   15 +++++++++++++++
 1 files changed, 15 insertions(+), 0 deletions(-)

diff --git a/arch/arm/mach-omap2/board-zoom3.c b/arch/arm/mach-omap2/board-zoom3.c
index 3314704..0b62663 100644
--- a/arch/arm/mach-omap2/board-zoom3.c
+++ b/arch/arm/mach-omap2/board-zoom3.c
@@ -46,6 +46,21 @@ static void __init omap_zoom_init_irq(void)
 
 #ifdef CONFIG_OMAP_MUX
 static struct omap_board_mux board_mux[] __initdata = {
+#ifdef CONFIG_OMAP_ZOOM_WLAN
+	/* WLAN IRQ - GPIO 162 */
+	OMAP3_MUX(MCBSP1_CLKX, OMAP_MUX_MODE4 | OMAP_PIN_INPUT_PULLUP),
+	/* WLAN POWER ENABLE - GPIO 101 */
+	OMAP3_MUX(CAM_D2, OMAP_MUX_MODE4 | OMAP_PIN_OUTPUT),
+	/* WLAN SDIO: MMC3 CMD */
+	OMAP3_MUX(MCSPI1_CS1, OMAP_MUX_MODE3 | OMAP_PIN_INPUT_PULLUP),
+	/* WLAN SDIO: MMC3 CLK */
+	OMAP3_MUX(ETK_CLK, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
+	/* WLAN SDIO: MMC3 DAT[0-3] */
+	OMAP3_MUX(ETK_D3, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
+	OMAP3_MUX(ETK_D4, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
+	OMAP3_MUX(ETK_D5, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
+	OMAP3_MUX(ETK_D6, OMAP_MUX_MODE2 | OMAP_PIN_INPUT_PULLUP),
+#endif
 	{ .reg_offset = OMAP_MUX_TERMINATOR },
 };
 #else