[PATCH v2] i2c-s3c2410: Remove unconditional 1ms delay on each transfer

[Joonyoung Shim]

On 4/2/2010 10:15 PM, Mark Brown wrote:
> The S3C I2C controller indicates completion of I2C transfers before
> the bus has a stop condition on it. In order to ensure that we do not
> attempt to start a new transfer before the bus is idle the driver
> currently inserts a 1ms delay. This is vastly larger than is generally
> required and has a visible effect on performance under load, such as
> when bringing up audio CODECs or reading back status information with
> non-bulk I2C reads.
> 
> Replace the sleep with a spin on the IIC status register for up to 1ms.
> This will busy wait but testing on my SMDK6410 system indicates that
> the overwhelming majority of transactions complete on the first spin,
> with maximum latencies of less than 10 spins so the absolute overhead
> of busy waiting should be at worst comprable to msleep(), and the
> overall system performance is dramatically improved.
> 
> The main risk is poor interaction with multimaster systems where
> we may miss the bus going idle before the next transaction. Defend
> against this by falling back to the original 1ms delay after 20 spins.
> 
> The overall effect in my testing is an approximately 20% improvement
> in kernel startup time.
> 

I tested this patch on the s5pc110. This occurs msleep(1) still by time 
out at the my touchscreen i2c device on the s5pc110. It takes 80usec to 
clear S3C2410_IICSTAT_START bit in the worst case of my touchscreen and
need about 400 spins. The 1msec delay is overhead to me still now.