[regression] 2.6.34-rc1 to -rc3 on zaurus: no longer boots

[Pavel Machek]

> >> > > > > I tried compiling 2.6.34-rc1, and it does not boot :-(. It does not
> >> > > > > seem to even reset the framebuffer (I'm using kexec -- so it stays
> >> > > > > stuck on on previous screen).
> >> > >
> >> > > Tried again with -rc2 and -rc3, and neither boots :-(. I did not have
> >> > > time to set up serial console, yet :-(. Any ideas?
> >> >
> >> > I created a Bugzilla entry at
> >> > https://bugzilla.kernel.org/show_bug.cgi?id=15712
> >> > for your bug report, please add your address to the CC list in there,
> >> >  thanks!
> >> >
> >> Pavel, you broke it ... and here you say something about sane arm maintainers
> >> ;-)
> >
> > ? You know which patch causes it ?
> 
> Just have some time to try this out on my corgi, and the kernel runs
> happily.
> 
> Pavel,
> 
> Which exact model are you running your kernel?

It is Zaurus SL-C3000 (aka spitz). I'm using kexec, but that used to
work. Should I try minimal config?
									Pavel

-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html