[PATCH 2/2] at91/USB: at91sam9g45 series USB host integration

Nicolas Ferre nicolas.ferre at atmel.com
Wed Sep 16 12:17:01 EDT 2009


Hi,

I come back on this topic as at91sam9g45 is now in mainline. I need this
integration code to have the USB EHCI work on the evaluation kit.

David Brownell :
> On Friday 19 June 2009, Haavard Skinnemoen wrote:
>> David Brownell wrote:
>>>> --- a/arch/arm/mach-at91/at91sam9g45_devices.c
>>>> +++ b/arch/arm/mach-at91/at91sam9g45_devices.c
>>>> +	/* Enable VBus control for UHP ports */
>>>> +	for (i = 0; i < data->ports; i++) {
>>>> +		if (data->vbus_pin[i])
>>>> +			at91_set_gpio_output(data->vbus_pin[i], 0);  
>>> This should gpio_request() and gpio_direction_output().
>> Hmm...I thought the driver was supposed to call gpio_request(), not the
>> platform code?
> 
> In some cases.  This isn't a good case for that.  Especially
> if it's going to call gpio_direction_output() ... which needs
> gpio_request() to have been done first.

Ok, I am building a patch on top of this one that uses these calls. This
way I can change both vbus pin configuration: OCHI and EHCI.

Best regards,
-- 
Nicolas Ferre




More information about the linux-arm-kernel mailing list