[PATCH 0/2 v2]mmc: atmel-mci: introduce MCI2 support on at91

[Nicolas Ferre]

This patchset introduces the support of a new revision of the MCI IP on AT91
SOCs. The use of an alternate DMA engine on those platforms introduces the need
of a generic way of handling dma slave interface.

Note: those patches goes on top of the following patch that is already in
mainline:
	atmel-mci: unified Atmel MCI drivers (AVR32 & AT91)

Nicolas Ferre (3):
      atmel-mci: change use of dma slave interface
      mmc: atmel-mci: New MCI2 module support in atmel-mci driver
      at91/atmel-mci: inclusion of sd/mmc driver in at91sam9g45 chip and board

 arch/arm/mach-at91/at91sam9g45_devices.c        |  164 +++++++++++++++++++++++
 arch/arm/mach-at91/board-sam9m10g45ek.c         |   24 ++++
 arch/arm/mach-at91/include/mach/atmel-mci.h     |   24 ++++
 arch/avr32/mach-at32ap/at32ap700x.c             |   18 ++-
 arch/avr32/mach-at32ap/include/mach/atmel-mci.h |   24 ++++
 drivers/mmc/host/Kconfig                        |    2 +-
 drivers/mmc/host/atmel-mci.c                    |  141 +++++++++++++++----
 include/linux/atmel-mci.h                       |    4 +-
 8 files changed, 362 insertions(+), 39 deletions(-)
 create mode 100644 arch/arm/mach-at91/include/mach/atmel-mci.h
 create mode 100644 arch/avr32/mach-at32ap/include/mach/atmel-mci.h