No subject


Fri Nov 6 13:01:15 EST 2009


    Sometimes you need to make an `asm' operand be a specific register,
    but there's no matching constraint letter for that register _by
    itself_.  To force the operand into that register, use a local variable
    for the operand and specify the register in the variable declaration.
    *Note Explicit Reg Vars::.  Then for the `asm' operand, use any
    register constraint letter that matches the register:

         register int *p1 asm ("r0") = ...;
         register int *p2 asm ("r1") = ...;
         register int *result asm ("r0");
         asm ("sysint" : "=r" (result) : "0" (p1), "r" (p2));

Fwiw, that note is present in GCC-4.0.1, but not GCC-3.3.6.  But we've
depended on that behaviour for a long time.

Note that we've depended on GCC not copying values with a dereferenced
memory location for a long time too: E.g. "+m" (*ptr) is used a lot in
spinlocks.

I'm sure I've read email confirmation (on these very lists) that GCC
will always work with a memory constraint used in that way, without
copying the value to/from a different location such as a stack slot.

But suprisingly, the GCC documentation says:

    Extended asm supports input-output or read-write operands.  Use
    the constraint character `+' to indicate such an operand and list
    it with the output operands.  You should only use read-write
    operands when the constraints for the operand (or the operand in
    which only some of the bits are to be changed) allow a register.
                                                   ^^^^^^^^^^^^^^^^

Maybe we're relying on undefined GCC behaviour for the "+m" constraint?

> See the __asmeq() macro in <asm/system.h> for a dirty hack which will
> check which registers are used and abort at compile time, although your
> compilation is going to fail anyway so I'm not sure it makes much of a
> difference in this particular case.
> 
> The real fix here is to add an asm constraint to GCC which allows you to
> specify "any even GPR" (or whatever's most suitable for the ldrd
> instruction). Being able to give specific registers, like you can on
> other architectures, would be useful too.

See above GCC documentation for using register variables to designate
specific registers.  Many supported architectures don't have asm
letter constraints for each register - hence so many of the old
_syscallN macros in <asm/unistd.h> having to use register variables.

I am surprised GCC doesn't have a constraint for "any even register
suitable for ldrd" on ARM, but I've just checked gcc-4.4.3 and it doesn't.

However, if I'm reading the source correctly, if not compiling for
Thumb-1, and GCC believes the target machine supports ldrd, then all
doubleword values are constrained to an even register pair anyway.
That's why GCC itself does not need an even-register constraint letter.

...Which is I guess why it throws up only with OABI, or with pre-arm5e
archs: GCC doesn't consider OABI targets to support ldrd.  (It's
actually some more obscure condition, let's not go there).

Something else from the lovely GCC source:

    mfix-cortex-m3-ldrd
    Target Report Var(fix_cm3_ldrd) Init(2)
    Avoid overlapping destination and address registers on LDRD instructions
    that may trigger Cortex-M3 errata.

In other words, the "=&" earlyclobber *is* needed on Cortex-M3.

Enjoy!
-- Jamie



More information about the linux-arm-kernel mailing list