[PATCH 6/8] omap: Split i2c platform init for mach-omap1 and mach-omap2

[Tony Lindgren]

* Tony Lindgren <tony at atomide.com> [091125 16:19]:
> Otherwise we cannot limit new mux code to mach-omap2.
> The same signal names should eventually work for other
> omaps under mach-omap2.
> 
> Note that these pins don't need to be OMAP_PIN_INPUT_PULLUP,
> just OMAP_PIN_INPUT is enough.

Here's a better version of this patch that actually does the
splitting. The earlier version was a bit of a hack.

Regards,

Tony