[RFC PATCH v2 1/7] net: stmmac: dwmac-meson8b: let the controller apply the RGMII delays

[Maxime Chevallier]

Hi Lucas,

On 10/7/26 10:26, Lucas Tanure wrote:
> RGMII needs a delay on each of its two clocks. A board can get it from
> the length of its tracks, from the PHY, or from the controller.
> "rgmii-id" in the device tree says the delay is added inside the chips
> but not which chip adds it, and the generic tx-internal-delay-ps and
> rx-internal-delay-ps properties name the controller.
> 
> This driver ignored those properties. In the "-id" modes it switched
> its own delays off and left the whole job to the PHY, so a board that
> asks the controller for one of them does not get it, and a board whose
> PHY cannot supply that delay has no usable link at all.
> 
> Boards not using those properties behave as before.
> 
> Assisted-by: LLM
> Signed-off-by: Lucas Tanure <tanure at linux.com>
> ---
>  .../ethernet/stmicro/stmmac/dwmac-meson8b.c   | 46 ++++++++++++++++++-
>  1 file changed, 44 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
> index e4d5c41294f4..d73dfd0ac167 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
> @@ -92,6 +92,8 @@ struct meson8b_dwmac {
>  	struct clk			*rgmii_tx_clk;
>  	u32				tx_delay_ns;
>  	u32				rx_delay_ps;
> +	bool				mac_tx_delay;
> +	bool				mac_rx_delay;
>  	struct clk			*timing_adj_clk;
>  };
>  
> @@ -299,6 +301,22 @@ static int meson8b_init_rgmii_delays(struct meson8b_dwmac *dwmac)
>  		delay_config = rx_adj_config;
>  		break;
>  	case PHY_INTERFACE_MODE_RGMII_ID:
> +		/*
> +		 * "rgmii-id" only says the delays are internal, not which
> +		 * side applies them. The *-internal-delay-ps properties say
> +		 * it is this controller, so leave ours switched on.
> +		 */
> +		if (dwmac->mac_tx_delay || dwmac->mac_rx_delay) {
> +			delay_config = 0;
> +			if (dwmac->mac_tx_delay)
> +				delay_config |= tx_dly_config;
> +			if (dwmac->mac_rx_delay)
> +				delay_config |= rx_adj_config;
> +			else
> +				cfg_rxclk_dly = 0;
> +			break;
> +		}
> +		fallthrough;
>  	case PHY_INTERFACE_MODE_RMII:
>  		delay_config = 0;
>  		cfg_rxclk_dly = 0;
> @@ -384,6 +402,7 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
>  	struct plat_stmmacenet_data *plat_dat;
>  	struct stmmac_resources stmmac_res;
>  	struct meson8b_dwmac *dwmac;
> +	u32 tx_delay_ps;
>  	int ret;
>  
>  	ret = stmmac_get_platform_resources(pdev, &stmmac_res);
> @@ -409,9 +428,13 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
>  	dwmac->dev = &pdev->dev;
>  	dwmac->phy_mode = plat_dat->phy_interface;
>  
> +	/* the generic property is preferred over the vendor one */
> +	if (!of_property_read_u32(pdev->dev.of_node, "tx-internal-delay-ps",
> +				  &tx_delay_ps))
> +		dwmac->tx_delay_ns = tx_delay_ps / 1000;
>  	/* use 2ns as fallback since this value was previously hardcoded */
> -	if (of_property_read_u32(pdev->dev.of_node, "amlogic,tx-delay-ns",
> -				 &dwmac->tx_delay_ns))
> +	else if (of_property_read_u32(pdev->dev.of_node, "amlogic,tx-delay-ns",
> +				      &dwmac->tx_delay_ns))
>  		dwmac->tx_delay_ns = 2;
>  
>  	/* RX delay defaults to 0ps since this is what many boards use */
> @@ -424,6 +447,25 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
>  			dwmac->rx_delay_ps *= 1000;
>  	}
>  
> +	/*
> +	 * Each property names one clock this controller delays itself. The
> +	 * PHY must be asked for whatever is left, or the two would delay the
> +	 * same clock and push it past the window.
> +	 */
> +	dwmac->mac_tx_delay = of_property_present(pdev->dev.of_node,
> +						  "tx-internal-delay-ps");
> +	dwmac->mac_rx_delay = of_property_present(pdev->dev.of_node,
> +						  "rx-internal-delay-ps");
> +
> +	if (dwmac->phy_mode == PHY_INTERFACE_MODE_RGMII_ID) {
> +		if (dwmac->mac_tx_delay && dwmac->mac_rx_delay)
> +			plat_dat->phy_interface = PHY_INTERFACE_MODE_RGMII;
> +		else if (dwmac->mac_tx_delay)
> +			plat_dat->phy_interface = PHY_INTERFACE_MODE_RGMII_RXID;
> +		else if (dwmac->mac_rx_delay)
> +			plat_dat->phy_interface = PHY_INTERFACE_MODE_RGMII_TXID;
> +	}

There's a helper for that :

phy_fix_phy_mode_for_mac_delays(), passed as parameters the mode, and wether the mac
inserts TX/RX delays, and it returns what you should hand out to the PHY :)

> +
>  	if (dwmac->data->has_prg_eth1_rgmii_rx_delay) {
>  		if (dwmac->rx_delay_ps > 3000 || dwmac->rx_delay_ps % 200) {
>  			dev_err(dwmac->dev,

This looks better, thanks for this :)

Maxime