[RFC PATCH v2 5/7] arm64: dts: amlogic: t7: add the ethernet pinctrl nodes

[Lucas Tanure]

The SoC brings its ethernet interface out on bank Z, but no pin groups
were described, so a board had no way to hand those pins over to the
MAC.

Describe them as the two sets a board actually needs: the nine pins the
interface always uses, and the five extra ones RGMII adds for its wider
data path.

Assisted-by: LLM
Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>
Signed-off-by: Lucas Tanure <tanure at linux.com>
---
 arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi | 30 +++++++++++++++++++++
 1 file changed, 30 insertions(+)

diff --git a/arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi b/arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi
index 6894c06a836b..7bd53ec16607 100644
--- a/arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi
+++ b/arch/arm64/boot/dts/amlogic/amlogic-t7.dtsi
@@ -376,6 +376,36 @@ mux {
 					};
 				};
 
+				eth_pins: eth {
+					mux {
+						groups = "eth_mdio",
+							 "eth_mdc",
+							 "eth_rgmii_rx_clk",
+							 "eth_rx_dv",
+							 "eth_rxd0",
+							 "eth_rxd1",
+							 "eth_txen",
+							 "eth_txd0",
+							 "eth_txd1";
+						function = "eth";
+						drive-strength-microamp = <4000>;
+						bias-disable;
+					};
+				};
+
+				eth_rgmii_pins: eth-rgmii {
+					mux {
+						groups = "eth_rxd2_rgmii",
+							 "eth_rxd3_rgmii",
+							 "eth_rgmii_tx_clk",
+							 "eth_txd2_rgmii",
+							 "eth_txd3_rgmii";
+						function = "eth";
+						drive-strength-microamp = <4000>;
+						bias-disable;
+					};
+				};
+
 				i2c0_ao_d_pins: i2c0-ao-d {
 					mux {
 						groups = "i2c0_ao_sck_d",
-- 
2.56.0