[PATCH v5 7/7] arm64: dts: amlogic: t7: khadas-vim4: enable the ethernet port

[Lucas Tanure]

The board carries a Realtek RTL8211F gigabit PHY on the external
management bus, connected to the MAC over RGMII.

Enable the controller and the management bus multiplexer, hand the
controller the ethernet pins and point it at the PHY on the external
bus. RGMII needs a delay on each of its two clocks. The board traces
add none, so the PHY adds both, which is what rgmii-id asks of it.

The PHY interrupt output is wired to GPIOH_6, so link changes are
reported instead of polled. The PHY reset is an RC network on the
board, not a SoC pin, so there is no reset line to describe.

Assisted-by: LLM
Signed-off-by: Lucas Tanure <tanure at linux.com>
---
 .../amlogic/amlogic-t7-a311d2-khadas-vim4.dts | 23 +++++++++++++++++++
 1 file changed, 23 insertions(+)

diff --git a/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts b/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts
index 0fa83362b417..93327b993d39 100644
--- a/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts
+++ b/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts
@@ -14,6 +14,7 @@ / {
 	compatible = "khadas,vim4", "amlogic,a311d2", "amlogic,t7";
 
 	aliases {
+		ethernet0 = ðmac;
 		serial0 = &uart_a;
 		mmc0 = &sd_emmc_c;
 		mmc1 = &sd_emmc_b;
@@ -256,6 +257,28 @@ xtal: xtal-clk {
 	};
 };
 
+&ethmac {
+	status = "okay";
+	pinctrl-0 = <&eth_pins>, <&eth_rgmii_pins>;
+	pinctrl-names = "default";
+	phy-mode = "rgmii-id";
+	phy-handle = <&external_phy>;
+};
+
+&eth_phy {
+	status = "okay";
+};
+
+&ext_mdio {
+	external_phy: ethernet-phy at 0 {
+		/* Realtek RTL8211FD-CG */
+		reg = <0>;
+
+		interrupt-parent = <&gpio_intc>;
+		interrupts = <GPIOH_6 IRQ_TYPE_LEVEL_LOW>;
+	};
+};
+
 &i2c_m_ao_a {
 	status = "okay";
 	pinctrl-0 = <&i2c0_ao_d_pins>;
-- 
2.56.0