[PATCH 05/10] clk: amlogic: PLL l_detect signal supports active-high configuration

[Jian Hu via B4 Relay]

From: Jian Hu <jian.hu at amlogic.com>

l_detect controls the enable/disable of the PLL lock-detect module.

For A9, the l_detect signal is active-high:
0 -> Disable lock-detect module;
1 -> Enable lock-detect module.

Here, a flag CLK_MESON_PLL_L_DETECT_ACTIVE_HIGH is added to handle cases
like A9, where the signal is active-high.

Signed-off-by: Jian Hu <jian.hu at amlogic.com>
---
 drivers/clk/meson/clk-pll.c | 9 +++++++--
 drivers/clk/meson/clk-pll.h | 2 ++
 2 files changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/clk/meson/clk-pll.c b/drivers/clk/meson/clk-pll.c
index 1ea6579a760f..5a0bd75f85a9 100644
--- a/drivers/clk/meson/clk-pll.c
+++ b/drivers/clk/meson/clk-pll.c
@@ -388,8 +388,13 @@ static int meson_clk_pll_enable(struct clk_hw *hw)
 	}
 
 	if (MESON_PARM_APPLICABLE(&pll->l_detect)) {
-		meson_parm_write(clk->map, &pll->l_detect, 1);
-		meson_parm_write(clk->map, &pll->l_detect, 0);
+		if (pll->flags & CLK_MESON_PLL_L_DETECT_ACTIVE_HIGH) {
+			meson_parm_write(clk->map, &pll->l_detect, 0);
+			meson_parm_write(clk->map, &pll->l_detect, 1);
+		} else {
+			meson_parm_write(clk->map, &pll->l_detect, 1);
+			meson_parm_write(clk->map, &pll->l_detect, 0);
+		}
 	}
 
 	if (meson_clk_pll_wait_lock(hw))
diff --git a/drivers/clk/meson/clk-pll.h b/drivers/clk/meson/clk-pll.h
index 949157fb7bf5..97b7c70376a3 100644
--- a/drivers/clk/meson/clk-pll.h
+++ b/drivers/clk/meson/clk-pll.h
@@ -29,6 +29,8 @@ struct pll_mult_range {
 
 #define CLK_MESON_PLL_ROUND_CLOSEST	BIT(0)
 #define CLK_MESON_PLL_NOINIT_ENABLED	BIT(1)
+/* l_detect signal is active-high */
+#define CLK_MESON_PLL_L_DETECT_ACTIVE_HIGH	BIT(2)
 
 struct meson_clk_pll_data {
 	struct parm en;

-- 
2.47.1