[PATCH net-next v13 00/10] net: stmmac: qcom-ethqos: add support for SCMI power domains

Bartosz Golaszewski bartosz.golaszewski at oss.qualcomm.com
Mon Jul 13 06:20:29 PDT 2026 

Add support for the firmware-managed variant of the DesignWare MAC on
the sa8255p platform. This series contains new DT bindings and driver
changes required to support the MAC in the STMMAC driver.

It also reorganizes the ethqos code quite a bit to make the introduction
of power domains into the driver a bit easier on the eye.

The DTS changes will go in separately.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at oss.qualcomm.com>
---
Changes in v13:
- Reapply OPP on speed change in the PHY driver
- Use linux/device-id/of.h instead of mod_devicetable.h
- Fix the "invalid PTP clock rate" warning on sa8255p
- Add commits necessary to allow correct link speed change with SCMI
- Link to v12: https://patch.msgid.link/20260706-qcom-sa8255p-emac-v12-0-e3ab1ecf2901@oss.qualcomm.com

Changes in v12:
- Drop the power-domain-names from the SGMII PHY DT bindings
- Add missing Kconfig dependency on PM for the new SGMII PHY driver
- Link to v11: https://patch.msgid.link/20260629-qcom-sa8255p-emac-v11-0-1b7fb95b51f9@oss.qualcomm.com

Changes in v11:
- Take a new approach: add a dedicated driver for the firmware-managed
  SGMII PHY and simplify changes made to the MAC driver
- Link to v10: https://patch.msgid.link/20260323-qcom-sa8255p-emac-v10-0-79302b238a16@oss.qualcomm.com

Changes in v10:
- Fix unit address in DT example
- Link to v9: https://patch.msgid.link/20260316-qcom-sa8255p-emac-v9-0-c58934e76ff2@oss.qualcomm.com

Changes in v9:
- Rebase on top of current linux-next again
- Link to v8: https://patch.msgid.link/20260311-qcom-sa8255p-emac-v8-0-58227bcf1018@oss.qualcomm.com

Changes in v8:
- Rebase on top of recent changes in linux-next which required an
  extensive rework
- Drop partial R-b tags
- Link to v7: https://patch.msgid.link/20260306-qcom-sa8255p-emac-v7-0-d6a3013094b7@oss.qualcomm.com

Changes in v7:
- Restored the correct authorship after learning git uses .mailmap for
  the --author switch
- Rebased on top of changes from Russell
- Fixed resource management issues in error paths
- Link to v6: https://lore.kernel.org/r/20260112-qcom-sa8255p-emac-v6-0-86a3d4b2ad83@oss.qualcomm.com

Changes in v6:
- Fix $id value in the bindings
- Drop patch 3/8 from the series
- Update init/exit callback signatures
- Link to v5: https://lore.kernel.org/r/20251107-qcom-sa8255p-emac-v5-0-01d3e3aaf388@linaro.org
- Link to v6: https://lore.kernel.org/r/20251219-qcom-sa8255p-emac-v6-0-487f1082461e@oss.qualcomm.com

Changes in v5:
- Name the DT binding document after the new compatbile
- Add missing space
- Make the power-domains limits stricter
- Link to v4: https://lore.kernel.org/r/20251104-qcom-sa8255p-emac-v4-0-f76660087cea@linaro.org

Changes in v4:
- Remove the phys property from the SCMI bindings
- Mark the power-domain-names property as required
- Set maxItems for power-domains to 1 for all existing bindings to
  maintain the current requirements after modifying the value in the
  top-level document
- Link to v3: https://lore.kernel.org/r/20251027-qcom-sa8255p-emac-v3-0-75767b9230ab@linaro.org

Changes in v3:
- Drop 'power' and 'perf' prefixes from power domain names
- Rebase on top of Russell's changes to dwmac
- Rebase on top of even more changes from Russell that are not yet
  in next (E1vB6ld-0000000BIPy-2Qi4 at rmk-PC.armlinux.org.uk)
- Link to v2: https://lore.kernel.org/all/20251008-qcom-sa8255p-emac-v2-0-92bc29309fce@linaro.org/

Changes in v2:
- Fix the power-domains property in DT bindings
- Rework the DT bindings example
- Drop the DTS patch, it will go upstream separately
- Link to v1: https://lore.kernel.org/r/20250910-qcom-sa8255p-emac-v1-0-32a79cf1e668@linaro.org

---
Bartosz Golaszewski (10):
      net: phy: aquantia: fix system interface type not updated in forced mode
      dt-bindings: phy: document the serdes PHY on sa8255p
      phy: qcom: add the SGMII SerDes PHY driver for SCMI systems
      dt-bindings: net: qcom: document the ethqos device for SCMI-based systems
      net: stmmac: qcom-ethqos: set serdes mode before powerup
      net: stmmac: qcom-ethqos: update phy_mode to the resolved interface in mac_finish()
      net: stmmac: qcom-ethqos: fix SGMII loopback not set on resume after speed change
      net: stmmac: qcom-ethqos: reuse the address of ethqos_emac_driver_data
      net: stmmac: qcom-ethqos: factor out linux-level setup into a separate function
      net: stmmac: qcom-ethqos: add support for sa8255p

 .../bindings/net/allwinner,sun7i-a20-gmac.yaml     |   3 +
 .../bindings/net/altr,socfpga-stmmac.yaml          |   3 +
 .../bindings/net/amlogic,meson-dwmac.yaml          |   3 +
 .../devicetree/bindings/net/eswin,eic7700-eth.yaml |   3 +
 .../devicetree/bindings/net/intel,dwmac-plat.yaml  |   3 +
 .../bindings/net/loongson,ls1b-gmac.yaml           |   3 +
 .../bindings/net/loongson,ls1c-emac.yaml           |   3 +
 .../devicetree/bindings/net/nxp,dwmac-imx.yaml     |   3 +
 .../devicetree/bindings/net/nxp,lpc1850-dwmac.yaml |   3 +
 .../devicetree/bindings/net/nxp,s32-dwmac.yaml     |   3 +
 .../devicetree/bindings/net/qcom,ethqos.yaml       |   3 +
 .../bindings/net/qcom,sa8255p-ethqos.yaml          | 107 +++++++++
 .../devicetree/bindings/net/renesas,rzn1-gmac.yaml |   3 +
 .../bindings/net/renesas,rzv2h-gbeth.yaml          |   3 +
 .../devicetree/bindings/net/rockchip-dwmac.yaml    |   3 +
 .../devicetree/bindings/net/snps,dwmac.yaml        |   5 +-
 .../bindings/net/sophgo,cv1800b-dwmac.yaml         |   3 +
 .../bindings/net/sophgo,sg2044-dwmac.yaml          |   3 +
 .../bindings/net/starfive,jh7110-dwmac.yaml        |   3 +
 .../devicetree/bindings/net/stm32-dwmac.yaml       |   3 +
 .../devicetree/bindings/net/tesla,fsd-ethqos.yaml  |   3 +
 .../devicetree/bindings/net/thead,th1520-gmac.yaml |   3 +
 .../bindings/net/toshiba,visconti-dwmac.yaml       |   3 +
 .../bindings/phy/qcom,sa8255p-dwmac-sgmii-phy.yaml |  50 +++++
 MAINTAINERS                                        |   1 +
 .../ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c    | 246 ++++++++++++++++-----
 drivers/net/phy/aquantia/aquantia_main.c           |   2 +-
 drivers/phy/qualcomm/Kconfig                       |  11 +
 drivers/phy/qualcomm/Makefile                      |   1 +
 drivers/phy/qualcomm/phy-qcom-sgmii-eth-scmi.c     | 165 ++++++++++++++
 30 files changed, 593 insertions(+), 58 deletions(-)
---
base-commit: 141ee96ad5c69b9d33b2b50ddd49315671023726
change-id: 20250704-qcom-sa8255p-emac-8460235ac512

Best regards,
-- 
Bartosz Golaszewski <bartosz.golaszewski at oss.qualcomm.com>

More information about the linux-amlogic mailing list