[PATCH net-next 15/16] net: stmmac: visconti: use PHY_INTF_SEL_x to select PHY interface

[Russell King (Oracle)]

Convert dwmac-visconti to use the PHY_INTF_SEL_x definitions. The
original definitions used constant 0, BIT(0) (==1) and BIT(2) (==4)
to define these, but the values of the bits corresponds with the
PHY_INTF_SEL_x values, so it is highly likely that these are not
individual bits, but the PHY_INTF_SEL_x bitfield.

This removes this incorrect use of BIT().

Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 drivers/net/ethernet/stmicro/stmmac/dwmac-visconti.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-visconti.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-visconti.c
index bd65d4239054..7b6b048e1be0 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-visconti.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-visconti.c
@@ -42,9 +42,9 @@
 
 #define ETHER_CLK_SEL_RX_TX_CLK_EN (ETHER_CLK_SEL_RX_CLK_EN | ETHER_CLK_SEL_TX_CLK_EN)
 
-#define ETHER_CONFIG_INTF_MII 0
-#define ETHER_CONFIG_INTF_RGMII BIT(0)
-#define ETHER_CONFIG_INTF_RMII BIT(2)
+#define ETHER_CONFIG_INTF_MII	PHY_INTF_SEL_GMII_MII
+#define ETHER_CONFIG_INTF_RGMII	PHY_INTF_SEL_RGMII
+#define ETHER_CONFIG_INTF_RMII	PHY_INTF_SEL_RMII
 
 struct visconti_eth {
 	void __iomem *reg;
-- 
2.47.3