[PATCH v1] arm64: dts: amlogic: Update USB hub power and reset properties

[Anand Moon]

Hi Neil,

On Tue, 20 May 2025 at 18:02, Neil Armstrong <neil.armstrong at linaro.org> wrote:
>
> On 20/05/2025 11:18, Anand Moon wrote:
> > Add missing reset-gpios property to the USB 2.0 hub node to
> > ensure proper reset handling. Also update the vdd-supply for
> > both USB 2.0 and 3.0 hubs to use the shared hub_5v regulator
> > for consistent power management.
> >
> > Fixes: ccff36934137 ("arm64: dts: amlogic: Used onboard usb hub reset on odroid n2")
> > Signed-off-by: Anand Moon <linux.amoon at gmail.com>
> > ---
> >   arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi | 5 +++--
> >   1 file changed, 3 insertions(+), 2 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
> > index 3bca8023638d..ad959f8bc1ac 100644
> > --- a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
> > +++ b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
> > @@ -42,7 +42,8 @@ hub_2_0: hub at 1 {
> >                       compatible = "usb5e3,610";
> >                       reg = <1>;
> >                       peer-hub = <&hub_3_0>;
> > -                     vdd-supply = <&usb_pwr_en>;
> > +                     reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
> > +                     vdd-supply = <&hub_5v>;
> >               };
> >
> >               /* 3.0 hub on port 4 */
> > @@ -51,7 +52,7 @@ hub_3_0: hub at 2 {
> >                       reg = <2>;
> >                       peer-hub = <&hub_2_0>;
> >                       reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
> > -                     vdd-supply = <&vcc_5v>;
> > +                     vdd-supply = <&hub_5v>;
>
> In this case, also remove the &usb2_phy1 phy-supply since now it's managed by the hub reset control.
>
Ok I will update in the next version.
> Neil
>
Thank
-Anand