[PATCH 13/25] ASoC: dt-bindings: meson: axg-pdm: document 'sysrate' property

Jan Dakinevich jan.dakinevich at salutedevices.com
Sun Mar 17 08:52:15 PDT 2024



On 3/15/24 13:22, Jerome Brunet wrote:
> 
> On Fri 15 Mar 2024 at 11:00, Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org> wrote:
> 
>> On 15/03/2024 00:21, Jan Dakinevich wrote:
>>> This option allow to redefine the rate of DSP system clock.
>>
>> And why is it suitable for bindings? Describe the hardware, not what you
>> want to do in the driver.
>>
>>>
>>> Signed-off-by: Jan Dakinevich <jan.dakinevich at salutedevices.com>
>>> ---
>>>  Documentation/devicetree/bindings/sound/amlogic,axg-pdm.yaml | 4 ++++
>>>  1 file changed, 4 insertions(+)
>>>
>>> diff --git a/Documentation/devicetree/bindings/sound/amlogic,axg-pdm.yaml b/Documentation/devicetree/bindings/sound/amlogic,axg-pdm.yaml
>>> index df21dd72fc65..d2f23a59a6b6 100644
>>> --- a/Documentation/devicetree/bindings/sound/amlogic,axg-pdm.yaml
>>> +++ b/Documentation/devicetree/bindings/sound/amlogic,axg-pdm.yaml
>>> @@ -40,6 +40,10 @@ properties:
>>>    resets:
>>>      maxItems: 1
>>>  
>>> +  sysrate:
>>> +    $ref: /schemas/types.yaml#/definitions/uint32
>>> +    description: redefine rate of DSP system clock
>>
>> No vendor prefix, so is it a generic property? Also, missing unit
>> suffix, but more importantly I don't understand why this is a property
>> of hardware.
> 
> +1.
> 
> The appropriate way to set rate of the clock before the driver take over
> is 'assigned-rate', if you need to customize this for different
> platform.
> 

It would be great, but it doesn't work. Below, is what I want to see:

	assigned-clocks =
		<&clkc_audio AUD2_CLKID_PDM_SYSCLK_SEL>,
		<&clkc_audio AUD2_CLKID_PDM_SYSCLK_DIV>;
	assigned-clock-parents =
		<&clkc_pll CLKID_FCLK_DIV3>,
		<0>;
	assigned-clock-rates =
		<0>,
		<256000000>;

But regardles of this declaration, PDM's driver unconditionally sets
sysclk'rate to 250MHz and throws away everything that was configured
before, reparents audio2_pdm_sysclk_mux to hifi_pll and changes
hifi_pll's rate.

This value 250MHz is declared here:

static const struct axg_pdm_cfg axg_pdm_config = {
	.filters = &axg_default_filters,
	.sys_rate = 250000000,
};

The property 'sysrate' is intended to redefine hardcoded 'sys_rate'
value in 'axg_pdm_config'.

> Then you don't have to deal with it in the device driver.
> 
>>
>> Best regards,
>> Krzysztof
> 
> 

-- 
Best regards
Jan Dakinevich



More information about the linux-amlogic mailing list