[PATCH 2/2] iio: frequency: add amlogic clock measure support

[David Lechner]

On 6/24/24 12:31 PM, Jerome Brunet wrote:
> Add support for the HW found in most Amlogic SoC dedicated to measure
> system clocks.
> 



> +static int cmsr_read_raw(struct iio_dev *indio_dev,
> +			 struct iio_chan_spec const *chan,
> +			 int *val, int *val2, long mask)
> +{
> +	struct amlogic_cmsr *cm = iio_priv(indio_dev);
> +
> +	guard(mutex)(&cm->lock);
> +
> +	switch (mask) {
> +	case IIO_CHAN_INFO_RAW:
> +		*val = cmsr_measure_unlocked(cm, chan->channel);

Is this actually returning an alternating voltage magnitutde?
Most frequency drivers don't have a raw value, only frequency.

> +		if (*val < 0)
> +			return *val;
> +		return IIO_VAL_INT;
> +
> +	case IIO_CHAN_INFO_PROCESSED: /* Result in Hz */

Shouldn't this be IIO_CHAN_INFO_FREQUENCY?

Processed is just (raw + offset) * scale which would be a voltage
in this case since the channel type is IIO_ALTVOLTAGE.

> +		*val = cmsr_measure_processed_unlocked(cm, chan->channel, val2);
> +		if (*val < 0)
> +			return *val;
> +		return IIO_VAL_INT_64;
> +
> +	case IIO_CHAN_INFO_SCALE:

What is this attribute being used for?

(clearly not used to convert the raw value to millivolts :-) )

Maybe IIO_CHAN_INFO_INT_TIME is the right one for this? Although
so far, that has only been used with light sensors.

> +		*val2 = cmsr_get_time_unlocked(cm);
> +		*val = 1000000;
> +		return IIO_VAL_FRACTIONAL;
> +
> +	default:
> +		return -EINVAL;
> +	}
> +}
> +