[PATCH v3 21/41] iio: gyro: bmg160_core: make use of regmap_clear_bits()

Trevor Gamblin tgamblin at baylibre.com
Mon Jun 17 06:50:01 PDT 2024


Instead of using regmap_update_bits() and passing val = 0, use
regmap_clear_bits().

Suggested-by: Uwe Kleine-König <u.kleine-koenig at baylibre.com>
Signed-off-by: Trevor Gamblin <tgamblin at baylibre.com>
---
 drivers/iio/gyro/bmg160_core.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/iio/gyro/bmg160_core.c b/drivers/iio/gyro/bmg160_core.c
index 0e2eb0e98235..10728d5ccae3 100644
--- a/drivers/iio/gyro/bmg160_core.c
+++ b/drivers/iio/gyro/bmg160_core.c
@@ -285,8 +285,8 @@ static int bmg160_chip_init(struct bmg160_data *data)
 	data->slope_thres = val;
 
 	/* Set default interrupt mode */
-	ret = regmap_update_bits(data->regmap, BMG160_REG_INT_EN_1,
-				 BMG160_INT1_BIT_OD, 0);
+	ret = regmap_clear_bits(data->regmap, BMG160_REG_INT_EN_1,
+				BMG160_INT1_BIT_OD);
 	if (ret < 0) {
 		dev_err(dev, "Error updating bits in reg_int_en_1\n");
 		return ret;

-- 
2.45.2




More information about the linux-amlogic mailing list