[PATCH 2/9] drm/meson: vclk: drop hdmi system clock setup

Neil Armstrong neil.armstrong at linaro.org
Mon Aug 19 09:01:32 PDT 2024


On 30/07/2024 14:50, Jerome Brunet wrote:
> Poking the HHI syscon is a way to setup clocks behind CCF's back.
> Also, 2 drm code paths, the encoder and the hdmi-phy, are racing to do the
> same setup of the HDMI system clock.
> 
> This clock is used is used by the HDMI phy and should not be set by the
> encoder, so drop those HHI pokes from vclk.
> 
> Signed-off-by: Jerome Brunet <jbrunet at baylibre.com>
> ---
>   drivers/gpu/drm/meson/meson_vclk.c | 8 --------
>   1 file changed, 8 deletions(-)
> 
> diff --git a/drivers/gpu/drm/meson/meson_vclk.c b/drivers/gpu/drm/meson/meson_vclk.c
> index 2a942dc6a6dc..bf5cc5d92346 100644
> --- a/drivers/gpu/drm/meson/meson_vclk.c
> +++ b/drivers/gpu/drm/meson/meson_vclk.c
> @@ -813,14 +813,6 @@ static void meson_vclk_set(struct meson_drm *priv, unsigned int pll_base_freq,
>   {
>   	unsigned int m = 0, frac = 0;
>   
> -	/* Set HDMI-TX sys clock */
> -	regmap_update_bits(priv->hhi, HHI_HDMI_CLK_CNTL,
> -			   CTS_HDMI_SYS_SEL_MASK, 0);
> -	regmap_update_bits(priv->hhi, HHI_HDMI_CLK_CNTL,
> -			   CTS_HDMI_SYS_DIV_MASK, 0);
> -	regmap_update_bits(priv->hhi, HHI_HDMI_CLK_CNTL,
> -			   CTS_HDMI_SYS_EN, CTS_HDMI_SYS_EN);
> -
>   	/* Set HDMI PLL rate */
>   	if (!od1 && !od2 && !od3) {
>   		meson_hdmi_pll_generic_set(priv, pll_base_freq);

Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>



More information about the linux-amlogic mailing list