[PATCH v2 4/4] PCI: kirin: Convert to agnostic GPIO API

Manivannan Sadhasivam manivannan.sadhasivam at linaro.org
Sat Apr 27 00:23:35 PDT 2024


On Tue, Apr 23, 2024 at 08:19:07PM +0300, Andy Shevchenko wrote:
> The of_gpio.h is going to be removed. In preparation of that convert
> the driver to the agnostic API.
> 
> Signed-off-by: Andy Shevchenko <andriy.shevchenko at linux.intel.com>
> Reviewed-by: Rob Herring <robh at kernel.org>
> ---
>  drivers/pci/controller/dwc/pcie-kirin.c | 105 ++++++++----------------
>  1 file changed, 35 insertions(+), 70 deletions(-)
> 
> diff --git a/drivers/pci/controller/dwc/pcie-kirin.c b/drivers/pci/controller/dwc/pcie-kirin.c
> index d5523f302102..1753ab63a541 100644
> --- a/drivers/pci/controller/dwc/pcie-kirin.c
> +++ b/drivers/pci/controller/dwc/pcie-kirin.c
> @@ -12,12 +12,10 @@
>  #include <linux/compiler.h>
>  #include <linux/delay.h>
>  #include <linux/err.h>
> -#include <linux/gpio.h>
>  #include <linux/gpio/consumer.h>
>  #include <linux/interrupt.h>
>  #include <linux/mfd/syscon.h>
>  #include <linux/of.h>
> -#include <linux/of_gpio.h>
>  #include <linux/of_pci.h>
>  #include <linux/phy/phy.h>
>  #include <linux/pci.h>
> @@ -78,16 +76,16 @@ struct kirin_pcie {
>  	void		*phy_priv;	/* only for PCIE_KIRIN_INTERNAL_PHY */
>  
>  	/* DWC PERST# */
> -	int		gpio_id_dwc_perst;
> +	struct gpio_desc *id_dwc_perst_gpio;
>  
>  	/* Per-slot PERST# */
>  	int		num_slots;
> -	int		gpio_id_reset[MAX_PCI_SLOTS];
> +	struct gpio_desc *id_reset_gpio[MAX_PCI_SLOTS];
>  	const char	*reset_names[MAX_PCI_SLOTS];
>  
>  	/* Per-slot clkreq */
>  	int		n_gpio_clkreq;
> -	int		gpio_id_clkreq[MAX_PCI_SLOTS];
> +	struct gpio_desc *id_clkreq_gpio[MAX_PCI_SLOTS];
>  	const char	*clkreq_names[MAX_PCI_SLOTS];
>  };
>  
> @@ -381,15 +379,20 @@ static int kirin_pcie_get_gpio_enable(struct kirin_pcie *pcie,
>  	pcie->n_gpio_clkreq = ret;
>  
>  	for (i = 0; i < pcie->n_gpio_clkreq; i++) {
> -		pcie->gpio_id_clkreq[i] = of_get_named_gpio(dev->of_node,
> -						    "hisilicon,clken-gpios", i);
> -		if (pcie->gpio_id_clkreq[i] < 0)
> -			return pcie->gpio_id_clkreq[i];
> +		pcie->id_clkreq_gpio[i] = devm_gpiod_get_index(dev,
> +							"hisilicon,clken", i,
> +							GPIOD_ASIS);

Please don't use GPIOD_ASIS even if the old code was using it.

For all 3 GPIOs in this driver, GPIOD_OUT_LOW flag should be used as the default
state is assert (considering the fact that the DT uses GPIO_ACTIVE_HIGH).

- Mani

> +		if (IS_ERR(pcie->id_clkreq_gpio[i]))
> +			return dev_err_probe(dev, PTR_ERR(pcie->id_clkreq_gpio[i]),
> +					     "unable to get a valid clken gpio\n");
>  
>  		pcie->clkreq_names[i] = devm_kasprintf(dev, GFP_KERNEL,
>  						       "pcie_clkreq_%d", i);
>  		if (!pcie->clkreq_names[i])
>  			return -ENOMEM;
> +
> +		gpiod_set_consumer_name(pcie->id_clkreq_gpio[i],
> +					pcie->clkreq_names[i]);
>  	}
>  
>  	return 0;
> @@ -407,10 +410,16 @@ static int kirin_pcie_parse_port(struct kirin_pcie *pcie,
>  		for_each_available_child_of_node(parent, child) {
>  			i = pcie->num_slots;
>  
> -			pcie->gpio_id_reset[i] = of_get_named_gpio(child,
> -							"reset-gpios", 0);
> -			if (pcie->gpio_id_reset[i] < 0)
> -				continue;
> +			pcie->id_reset_gpio[i] = devm_fwnode_gpiod_get_index(dev,
> +							 of_fwnode_handle(child),
> +							 "reset", 0, GPIOD_ASIS,
> +							 NULL);
> +			if (IS_ERR(pcie->id_reset_gpio[i])) {
> +				if (PTR_ERR(pcie->id_reset_gpio[i]) == -ENOENT)
> +					continue;
> +				return dev_err_probe(dev, PTR_ERR(pcie->id_reset_gpio[i]),
> +						     "unable to get a valid reset gpio\n");
> +			}
>  
>  			pcie->num_slots++;
>  			if (pcie->num_slots > MAX_PCI_SLOTS) {
> @@ -434,6 +443,9 @@ static int kirin_pcie_parse_port(struct kirin_pcie *pcie,
>  				ret = -ENOMEM;
>  				goto put_node;
>  			}
> +
> +			gpiod_set_consumer_name(pcie->id_reset_gpio[i],
> +						pcie->reset_names[i]);
>  		}
>  	}
>  
> @@ -463,14 +475,11 @@ static long kirin_pcie_get_resource(struct kirin_pcie *kirin_pcie,
>  		return PTR_ERR(kirin_pcie->apb);
>  
>  	/* pcie internal PERST# gpio */
> -	kirin_pcie->gpio_id_dwc_perst = of_get_named_gpio(dev->of_node,
> -							  "reset-gpios", 0);
> -	if (kirin_pcie->gpio_id_dwc_perst == -EPROBE_DEFER) {
> -		return -EPROBE_DEFER;
> -	} else if (!gpio_is_valid(kirin_pcie->gpio_id_dwc_perst)) {
> -		dev_err(dev, "unable to get a valid gpio pin\n");
> -		return -ENODEV;
> -	}
> +	kirin_pcie->id_dwc_perst_gpio = devm_gpiod_get(dev, "reset", GPIOD_ASIS);
> +	if (IS_ERR(kirin_pcie->id_dwc_perst_gpio))
> +		return dev_err_probe(dev, PTR_ERR(kirin_pcie->id_dwc_perst_gpio),
> +				     "unable to get a valid gpio pin\n");
> +	gpiod_set_consumer_name(kirin_pcie->id_dwc_perst_gpio, "pcie_perst_bridge");
>  
>  	ret = kirin_pcie_get_gpio_enable(kirin_pcie, pdev);
>  	if (ret)
> @@ -553,7 +562,7 @@ static int kirin_pcie_add_bus(struct pci_bus *bus)
>  
>  	/* Send PERST# to each slot */
>  	for (i = 0; i < kirin_pcie->num_slots; i++) {
> -		ret = gpio_direction_output(kirin_pcie->gpio_id_reset[i], 1);
> +		ret = gpiod_direction_output_raw(kirin_pcie->id_reset_gpio[i], 1);
>  		if (ret) {
>  			dev_err(pci->dev, "PERST# %s error: %d\n",
>  				kirin_pcie->reset_names[i], ret);
> @@ -623,44 +632,6 @@ static int kirin_pcie_host_init(struct dw_pcie_rp *pp)
>  	return 0;
>  }
>  
> -static int kirin_pcie_gpio_request(struct kirin_pcie *kirin_pcie,
> -				   struct device *dev)
> -{
> -	int ret, i;
> -
> -	for (i = 0; i < kirin_pcie->num_slots; i++) {
> -		if (!gpio_is_valid(kirin_pcie->gpio_id_reset[i])) {
> -			dev_err(dev, "unable to get a valid %s gpio\n",
> -				kirin_pcie->reset_names[i]);
> -			return -ENODEV;
> -		}
> -
> -		ret = devm_gpio_request(dev, kirin_pcie->gpio_id_reset[i],
> -					kirin_pcie->reset_names[i]);
> -		if (ret)
> -			return ret;
> -	}
> -
> -	for (i = 0; i < kirin_pcie->n_gpio_clkreq; i++) {
> -		if (!gpio_is_valid(kirin_pcie->gpio_id_clkreq[i])) {
> -			dev_err(dev, "unable to get a valid %s gpio\n",
> -				kirin_pcie->clkreq_names[i]);
> -			return -ENODEV;
> -		}
> -
> -		ret = devm_gpio_request(dev, kirin_pcie->gpio_id_clkreq[i],
> -					kirin_pcie->clkreq_names[i]);
> -		if (ret)
> -			return ret;
> -
> -		ret = gpio_direction_output(kirin_pcie->gpio_id_clkreq[i], 0);
> -		if (ret)
> -			return ret;
> -	}
> -
> -	return 0;
> -}
> -
>  static const struct dw_pcie_ops kirin_dw_pcie_ops = {
>  	.read_dbi = kirin_pcie_read_dbi,
>  	.write_dbi = kirin_pcie_write_dbi,
> @@ -680,7 +651,7 @@ static int kirin_pcie_power_off(struct kirin_pcie *kirin_pcie)
>  		return hi3660_pcie_phy_power_off(kirin_pcie);
>  
>  	for (i = 0; i < kirin_pcie->n_gpio_clkreq; i++)
> -		gpio_direction_output(kirin_pcie->gpio_id_clkreq[i], 1);
> +		gpiod_direction_output_raw(kirin_pcie->id_clkreq_gpio[i], 1);
>  
>  	phy_power_off(kirin_pcie->phy);
>  	phy_exit(kirin_pcie->phy);
> @@ -707,10 +678,6 @@ static int kirin_pcie_power_on(struct platform_device *pdev,
>  		if (IS_ERR(kirin_pcie->phy))
>  			return PTR_ERR(kirin_pcie->phy);
>  
> -		ret = kirin_pcie_gpio_request(kirin_pcie, dev);
> -		if (ret)
> -			return ret;
> -
>  		ret = phy_init(kirin_pcie->phy);
>  		if (ret)
>  			goto err;
> @@ -723,11 +690,9 @@ static int kirin_pcie_power_on(struct platform_device *pdev,
>  	/* perst assert Endpoint */
>  	usleep_range(REF_2_PERST_MIN, REF_2_PERST_MAX);
>  
> -	if (!gpio_request(kirin_pcie->gpio_id_dwc_perst, "pcie_perst_bridge")) {
> -		ret = gpio_direction_output(kirin_pcie->gpio_id_dwc_perst, 1);
> -		if (ret)
> -			goto err;
> -	}
> +	ret = gpiod_direction_output_raw(kirin_pcie->id_dwc_perst_gpio, 1);
> +	if (ret)
> +		goto err;
>  
>  	usleep_range(PERST_2_ACCESS_MIN, PERST_2_ACCESS_MAX);
>  
> -- 
> 2.43.0.rc1.1336.g36b5255a03ac
> 

-- 
மணிவண்ணன் சதாசிவம்



More information about the linux-amlogic mailing list