[PATCH v1] arm64: dts: amlogic: Used onboard usb hub reset on odroid n2

[Anand Moon]

Hi Neil,

On Tue, 10 Oct 2023 at 13:40, Neil Armstrong <neil.armstrong at linaro.org> wrote:
>
> Hi,
>
> On 10/10/2023 05:24, Anand Moon wrote:
> > On Odroid n2/n2+ previously use gpio-hog to reset the usb hub,
> > switch to used on-board usb hub reset to enable the usb hub
> > and enable power to hub.
> >
> > Signed-off-by: Anand Moon <linux.amoon at gmail.com>
> > ---
> >   .../dts/amlogic/meson-g12b-odroid-n2.dtsi     | 36 ++++++++++++-------
> >   1 file changed, 24 insertions(+), 12 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
> > index 91c9769fda20..9e671444eca6 100644
> > --- a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
> > +++ b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
> > @@ -31,6 +31,30 @@ hub_5v: regulator-hub_5v {
> >               enable-active-high;
> >       };
> >
> > +     /* USB hub supports both USB 2.0 and USB 3.0 root hub */
> > +     usb-hub {
> > +             dr_mode = "host";
> > +             #address-cells = <1>;
> > +             #size-cells = <0>;
> > +
> > +             /* 2.0 hub on port 1 */
> > +             hub_2_0: hub at 1 {
> > +                     compatible = "usb5e3,610";
> > +                     reg = <1>;
> > +                     peer-hub = <&hub_3_0>;
>
> It seems peer-hub is missing from Documentation/devicetree/bindings/usb/genesys,gl850g.yaml, could you add it ?
>
Yes, will add an example in genesys,gl850g.yaml file.

> Thanks,
> Neil

Thanks
-Anand