[PATCH v1 1/6] arm64: dts: meson: a1: introduce PLL and Peripherals clk controllers

Martin Blumenstingl martin.blumenstingl at googlemail.com
Sun Jun 25 14:00:06 PDT 2023


On Wed, Jun 7, 2023 at 10:16 PM Dmitry Rokosov <ddrokosov at sberdevices.ru> wrote:
>
> This patch adds clkc and clkc_pll dts nodes to A1 SoC main dtsi.
> The first one clk controller is responsible for all SoC peripherals
> clocks excluding audio clocks. The second one clk controller is used by
> A1 SoC PLLs. Actually, there are two different APB heads, so we have two
> different drivers.
>
> Signed-off-by: Dmitry Rokosov <ddrokosov at sberdevices.ru>
> ---
>  arch/arm64/boot/dts/amlogic/meson-a1.dtsi | 26 +++++++++++++++++++++++
>  1 file changed, 26 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/amlogic/meson-a1.dtsi b/arch/arm64/boot/dts/amlogic/meson-a1.dtsi
> index eed96f262844..a24228808c9c 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-a1.dtsi
> +++ b/arch/arm64/boot/dts/amlogic/meson-a1.dtsi
> @@ -6,6 +6,8 @@
>  #include <dt-bindings/interrupt-controller/irq.h>
>  #include <dt-bindings/interrupt-controller/arm-gic.h>
>  #include <dt-bindings/gpio/meson-a1-gpio.h>
> +#include <dt-bindings/clock/amlogic,a1-pll-clkc.h>
> +#include <dt-bindings/clock/amlogic,a1-peripherals-clkc.h>
>
>  / {
>         compatible = "amlogic,a1";
> @@ -126,6 +128,30 @@ uart_AO_B: serial at 2000 {
>                                 status = "disabled";
>                         };
>
> +                       clkc_periphs: clock-controller at 800 {
please keep the entries sorted - so &clkc_periphs should come after
&periphs_pinctrl

> +                               compatible = "amlogic,a1-peripherals-clkc";
> +                               reg = <0 0x800 0 0x104>;
> +                               #clock-cells = <1>;
> +                               clocks = <&clkc_pll CLKID_FCLK_DIV2>,
> +                                        <&clkc_pll CLKID_FCLK_DIV3>,
> +                                        <&clkc_pll CLKID_FCLK_DIV5>,
> +                                        <&clkc_pll CLKID_FCLK_DIV7>,
> +                                        <&clkc_pll CLKID_HIFI_PLL>,
> +                                        <&xtal>;
> +                               clock-names = "fclk_div2", "fclk_div3",
> +                                             "fclk_div5", "fclk_div7",
> +                                             "hifi_pll", "xtal";
> +                       };
[...]

>                         gpio_intc: interrupt-controller at 0440 {
note to self: at some point we'll have to re-order &gpio_intc, but
that's out of scope for this patch


Best regards,
Martin



More information about the linux-amlogic mailing list