[PATCH v3 net 2/2] net: stmmac: dwmac-imx: pause the TXC clock in fixed-link
Johannes Zink
j.zink at pengutronix.de
Tue Aug 1 05:47:46 PDT 2023
Hi Shenwei,
thanks for your patch.
On 7/31/23 18:19, Shenwei Wang wrote:
> When using a fixed-link setup, certain devices like the SJA1105 require a
> small pause in the TXC clock line to enable their internal tunable
> delay line (TDL).
If this is only required for some devices, is it safe to enforce this behaviour
unconditionally for any kind of fixed link devices connected to the MX93 EQOS
or could this possibly break for other devices?
Best regards
Johannes
>
> To satisfy this requirement, this patch temporarily disables the TX clock,
> and restarts it after a required period. This provides the required
> silent interval on the clock line for SJA1105 to complete the frequency
> transition and enable the internal TDLs.
>
> So far we have only enabled this feature on the i.MX93 platform.
>
> Signed-off-by: Shenwei Wang <shenwei.wang at nxp.com>
> Reviewed-by: Frank Li <frank.li at nxp.com>
> ---
> .../net/ethernet/stmicro/stmmac/dwmac-imx.c | 42 +++++++++++++++++++
> 1 file changed, 42 insertions(+)
>
> diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c
> index 53ee5a42c071..2e4173d099f3 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c
> @@ -32,6 +32,7 @@
> #define GPR_ENET_QOS_RGMII_EN (0x1 << 21)
>
> #define MX93_GPR_ENET_QOS_INTF_MODE_MASK GENMASK(3, 0)
> +#define MX93_GPR_ENET_QOS_INTF_MASK GENMASK(3, 1)
> #define MX93_GPR_ENET_QOS_INTF_SEL_MII (0x0 << 1)
> #define MX93_GPR_ENET_QOS_INTF_SEL_RMII (0x4 << 1)
> #define MX93_GPR_ENET_QOS_INTF_SEL_RGMII (0x1 << 1)
> @@ -40,6 +41,7 @@
> #define DMA_BUS_MODE 0x00001000
> #define DMA_BUS_MODE_SFT_RESET (0x1 << 0)
> #define RMII_RESET_SPEED (0x3 << 14)
> +#define CTRL_SPEED_MASK GENMASK(15, 14)
>
> struct imx_dwmac_ops {
> u32 addr_width;
> @@ -56,6 +58,7 @@ struct imx_priv_data {
> struct regmap *intf_regmap;
> u32 intf_reg_off;
> bool rmii_refclk_ext;
> + void __iomem *base_addr;
>
> const struct imx_dwmac_ops *ops;
> struct plat_stmmacenet_data *plat_dat;
> @@ -212,6 +215,42 @@ static void imx_dwmac_fix_speed(void *priv, uint speed, uint mode)
> dev_err(dwmac->dev, "failed to set tx rate %lu\n", rate);
> }
>
> +static void imx_dwmac_fix_speed_mx93(void *priv, uint speed, uint mode)
> +{
> + struct imx_priv_data *dwmac = priv;
> + int ctrl, old_ctrl, iface;
> +
> + imx_dwmac_fix_speed(priv, speed, mode);
> +
> + if (!dwmac || mode != MLO_AN_FIXED)
> + return;
> +
> + if (regmap_read(dwmac->intf_regmap, dwmac->intf_reg_off, &iface))
> + return;
> +
> + iface &= MX93_GPR_ENET_QOS_INTF_MASK;
> + if (iface != MX93_GPR_ENET_QOS_INTF_SEL_RGMII)
> + return;
> +
> + old_ctrl = readl(dwmac->base_addr + MAC_CTRL_REG);
> + ctrl = old_ctrl & ~CTRL_SPEED_MASK;
> + regmap_update_bits(dwmac->intf_regmap, dwmac->intf_reg_off,
> + MX93_GPR_ENET_QOS_INTF_MODE_MASK, 0);
> + writel(ctrl, dwmac->base_addr + MAC_CTRL_REG);
> +
> + /* Ensure the settings for CTRL are applied and avoid CPU/Compiler
> + * reordering.
> + */
> + wmb();
> +
> + usleep_range(10, 20);
> + iface |= MX93_GPR_ENET_QOS_CLK_GEN_EN;
> + regmap_update_bits(dwmac->intf_regmap, dwmac->intf_reg_off,
> + MX93_GPR_ENET_QOS_INTF_MODE_MASK, iface);
> +
> + writel(old_ctrl, dwmac->base_addr + MAC_CTRL_REG);
> +}
> +
> static int imx_dwmac_mx93_reset(void *priv, void __iomem *ioaddr)
> {
> struct plat_stmmacenet_data *plat_dat = priv;
> @@ -317,8 +356,11 @@ static int imx_dwmac_probe(struct platform_device *pdev)
> plat_dat->exit = imx_dwmac_exit;
> plat_dat->clks_config = imx_dwmac_clks_config;
> plat_dat->fix_mac_speed = imx_dwmac_fix_speed;
> + if (of_machine_is_compatible("fsl,imx93"))
> + plat_dat->fix_mac_speed = imx_dwmac_fix_speed_mx93;
> plat_dat->bsp_priv = dwmac;
> dwmac->plat_dat = plat_dat;
> + dwmac->base_addr = stmmac_res.addr;
>
> ret = imx_dwmac_clks_config(dwmac, true);
> if (ret)
--
Pengutronix e.K. | Johannes Zink |
Steuerwalder Str. 21 | https://www.pengutronix.de/ |
31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686| Fax: +49-5121-206917-5555 |
More information about the linux-amlogic
mailing list